Ford · Fusion

2009 Ford Fusion Brakes Problems

Midsize car · 4WD/AWD, FWD · Regular

Owners of the 2009 Ford Fusion have reported 531 brakes problems to NHTSA, 52% of all complaints about this model year.

Where owners named a specific part, the most common were antilock (4), antilock/traction control/electronic limited slip (3), and pedals and linkages (1).

The typical report came at around 101,000 miles, and complaints were filed between April 2009 and October 2026.

These brakes complaints include 42 crashes, 1 fire, and 9 injuries.

For comparison, the 2010 Fusion has the most brakes complaints of any year, with 548.

Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.

1 recall for this model year involves the brakes. If your problem matches, a dealer repairs it free under the recall.
Complaints531
Typical mileage101k
Crashes / fires42 / 1
Injuries9

Parts named in these complaints

  • Antilock4
  • Antilock/Traction Control/Electronic Limited Slip3
  • Pedals And Linkages1
  • Foundation Components1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Brakes Filed Oct 2026 MI

The contact owns a 2009 Ford Fusion. The contact stated that while driving 20 MPH and coming to a complete stop at a traffic light, the brake pedal was depressed but traveled down to the floorboard. The contact shifted into neutral(N) and continued to pump the brake pedal until the vehicle responded. The vehicle was taken to the dealer to be repaired under NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic). The brake calipers and the brake master cylinder were replaced, and the ABS module was cleaned; however, the failure persisted, and the contact was advised to retrieve the vehicle.

Owner complaint 11769237 filed with NHTSA
Brakes Filed Sep 2026 AZ

Dear NHTSA, The braking system failed which was covered by Ford Safety Recall 19S54 with NHTSA campaign #19V904000 at 37,750 miles. After research and finding the label of the ABS Hydraulic Control Unit still on the vehicle, being manufactured 07/12/2008, picture attached, it turned out to be the original HCU, whose failures were the reason for the Safety Recall. A Ford dealer had performed software evaluation of the ABS HCU and determined replacement of unit not necessary. This was done on 4/14/2021 at 17,606 miles along with break fluid change to DOT4 and reservoir cap change.

Owner complaint 11762013 filed with NHTSA
Brakes Filed Apr 2026 110,000 miles KY

The contact owns a 2009 Ford Fusion. The contact stated that the vehicle was taken to an independent mechanic for brake repairs, and after the repairs, the brake pedal felt spongy. The independent mechanic performed further inspections and diagnosed the vehicle with insufficient brake pressure due to a failure of the ABS hydraulic control unit. The manufacturer was notified of the failure. The contact related the failure to NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic); however, the VIN was not included. The approximate failure mileage was 110,000.

Owner complaint 11732434 filed with NHTSA

Related recalls

19V904000 Filed Dec 18, 2019 600,166 vehicles

Control unit/module

Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.

Risk and remedy
Risk
If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.
Remedy
Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S54.
Filed by
Ford Motor Company (manufacturer number 19S54)

Brakes complaints across Fusion years

Questions about brakes problems

How common are brakes problems on the 2009 Ford Fusion?

531 owners have reported brakes problems to NHTSA, 52% of all complaints for this model year.

Is there a recall for brakes problems on the 2009 Ford Fusion?

Yes. 1 recall for this model year concerns the brakes: 19V904000.