Owners of the 2015 GMC Sierra 1500 have reported 229 brakes problems to NHTSA, 32% of all complaints about this model year.
Where owners named a specific part, the most common were pedals and linkages (2), power assist (2), and brake fluid low warning (1).
The typical report came at around 56,000 miles, and complaints were filed between February 2017 and July 2026.
These brakes complaints include 15 crashes, 2 fires, and 2 injuries.
No other Sierra 1500 year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Complaints229
Typical mileage56k
Crashes / fires15 / 2
Injuries2
Parts named in these complaints
Pedals And Linkages2
Power Assist2
Brake Fluid Low Warning1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jul 2026MS
When backing up, either on a hill or flat surface, the brakes fail to stop the vehicle. There is a pulsing sensation with the brakes due to failure of the vacuum. The brake pedal also becomes impossible to depress. No warning lights appear when this occurs.
Owner complaint 11748839 filed with NHTSA
BrakesFiled May 202690,100 milesKS
The contact owns a 2015 GMC Sierra. The contact stated that while driving at an undisclosed speed and also while the vehicle was parked, the ABS and stability control warning lights would unexpectedly illuminate. The vehicle was taken to an independent mechanic, where the warning lights were cleared. The contact was informed that if the failure recurred, the EBCM and BPMV would need to be replaced. The vehicle was not repaired. The contact stated that the failure recurred. The vehicle was then taken to the dealer, where it was diagnosed that the EBCM and BPMV had failed and needed to be replaced. The vehicle was not repaired.
Owner complaint 11737603 filed with NHTSA
BrakesFiled Mar 2026NM
I had and still have the Brake Assist failure warning light on and having issues with brake pedal effort not working as it should to stop vehicle and also the stability control warning lights., the brakes hardly work at all at low speeds and most of the time don't stop the vehicle almost causing several crashes. I took vehicle to gm service center and they said they updated software but when I picked up the vehicle and drove it not long after the brake assist warning came back on and I still had no brakes at slower speeds and the problem had actually gotten worse than it was before i took it to them.
General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, while the vehicle is traveling between 41 and 60 mph in four-wheel or automatic mode, the Electronic-Brake Control Module (EBCM) software may activate the driveline-protection system.
Risk and remedy
Risk
Unintended activation of the driveline-protection system will cause unintended braking on the wheel on the opposite side of the failed sensor, causing the vehicle to pull to one side unexpectedly, increasing the risk of a crash.
Remedy
GM will notify owners, and dealers will reprogram the EBCM, free of charge. The recall began December 11, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192261050.
Filed by
General Motors LLC (manufacturer number N192261050)
General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.
Risk and remedy
Risk
As the vacuum level drops, the brake assist decreases, increasing braking effort, extending the distance required to stop the vehicle, thereby increasing the risk of a crash.
Remedy
GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began October 8, 2019. Owners may contact Chevrolet customer service at 1-800-630-2438, Cadillac customer service at 1-800-458-8006 or GMC customer service at 1-800-462-8782. GM's number for this recall is N192268490.
Filed by
General Motors LLC (manufacturer number N192268490)