Owners of the 1996 GMC Sonoma have reported 52 brakes problems to NHTSA, 35% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (36), foundation components (15), and power assist (4).
The typical report came at around 99,000 miles, and complaints were filed between February 1996 and July 2007.
These brakes complaints include 16 crashes and 2 injuries.
For comparison, the 1994 Sonoma has the most brakes complaints of any year, with 136.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jul 2007104,980 milesCT
Tl*the contact owns a 1996 GMC Sonoma. While applying the brakes AT 55 MPH, the brake pedal extended all the way to the floor. The emergency brake was applied to stop the vehicle. The contact was a mechanic and he replaced the front brake line for the passenger side wheel. The failure was corrected temporarily. However, twenty miles later, the failure recurred while driving 30 MPH. The brake line for the front driver side was replaced. The road conditions were normal during both failures.
Owner complaint 10197545 filed with NHTSA
BrakesFiled Nov 200698,651 milesOH
Dt*: the contact stated while driving 40 MPH under normal braking on wet roads, the ABS lights illuminated and the vehicle had an extended stopping distance. The dealer examined the vehicle and determined the three sensors had to be replaced, but were not certain that the replacement would correct the problem. The vehicle was currently AT the dealer for further repairs. The contact encountered NHTSA recall # 99i006000 regarding the service brakes, hydraulic: antilock.
Owner complaint 10173684 filed with NHTSA
BrakesFiled Feb 200439,000 milesAL
ABS anti-brake system has failed. Light continuously stays on. Analysis has determined that three of the four sensors are bad. Vehicle has only 40,000 miles on it. Also analysis has determined that the catalictic converter is defective, causing the service engine soon "light" to be on continuously.
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Vehicle description: light duty passenger pickup trucks equipped with 4.3l engines. The front brake line CAN contact the left-hand side of the engine oil pan causing the brake line to wear to the point of brake fluid loss during brake application.
Risk and remedy
Risk
Brake fluid loss CAN reduce braking effectiveness and increase stopping distances resulting in a vehicle crash without prior warning.
Remedy
Dealers will inspect the clearance between the oil pan and the brake line. If the clearance is 6mm or less, dealers will install an additional brake line clip and if there was contact between the oil pan and brake line, the front brake line will be replaced.