Owners of the 2000 GMC Sonoma have reported 35 brakes problems to NHTSA, 26% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (27), foundation components (5), and brake fluid low warning (1).
The typical report came at around 84,000 miles, and complaints were filed between March 2000 and July 2020.
These brakes complaints include 8 crashes and 3 injuries.
For comparison, the 1994 Sonoma has the most brakes complaints of any year, with 136.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jul 2020102,000 milesME
I had a near death accidents (twice) due to catastrophic brake line failure from severely rusted brake lines the front left and the intermediate line from front to rear section on top of frame rail. First incident was AT speed of 45 MPH on highway with hard stop required to avoid stopped traffic ahead. Second failure was more insidious with progressive brake line rust through/ leak spot to rear brake lines with fin through and failure. This is not complicated ... Simply substandard materials for one of the most critical components in a vehicle.
Owner complaint 11338735 filed with NHTSA
BrakesFiled Apr 2017101,000 milesNY
For the third time my brake line broke and lost all brakes in motion luck for me and my wife we were able to pull off the road going to have it towed to a shop for repair again what is going on with GMC quality and safety.
Owner complaint 10978723 filed with NHTSA
BrakesFiled Jun 201328,000 milesNC
On 19 June 2013 I applied the brakes on a damp/wet road. Before coming to a complete stop I experienced a sort of hopping of the front end while going over a rough section of roadway. This sensation has occurred numerous times before and I was told it had something to do with the anti-locking brake system but nothing specific.
Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (ABS) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the ABS would be non-functional.
Risk and remedy
Risk
The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.
Remedy
Dealers will replace the brake pressure module valve assembly.
Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."
Risk and remedy
Risk
If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.
Remedy
Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.