Owners of the 2000 GMC Yukon XL have reported 31 brakes problems to NHTSA, 45% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (12), antilock (5), and foundation components (2).
The typical report came at around 70,000 miles, and complaints were filed between July 2002 and December 2017.
These brakes complaints include 5 crashes and 5 injuries.
For comparison, the 2001 Yukon XL has the most brakes complaints of any year, with 70.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Dec 2017180,000 milesFL
Tl* the contact owns a 2000 GMC Yukon XL. While driving 55 MPH, the vehicle made a sputtering noise and stalled. The contact then stated that the anti-lock brake and check engine indicators illuminated. The contact's boyfriend called smith buick GMC AT 321-405-3488 (510 e nasa blvd, melbourne, fl 32901), but the call was disconnected. The vehicle was not diagnosed or repaired. The manufacturer was not notified. The approximate failure mileage was 180,000.
Owner complaint 11055689 filed with NHTSA
BrakesFiled Sep 2014145,000 milesVA
Applied pressure to brake pedal and it went to the floor. Took the car to a midas muffler garage as it was closest for diagnosis and found that the brake line had rusted away. It had rusted out AT the point where it goes over the top of the gas tank. They told me that they have seen this many times on these cars.
Owner complaint 10633696 filed with NHTSA
BrakesFiled Jan 201369,000 milesTX
The first time the ABS ebcu failed we had only owned the car a few years. We figured out something was wrong by the continuous growling buzz under the vehicle. We had to full the fuse to disconnect the unit to prevent it from running down the battery while we tried to learn exactly what was wrong. ----------- on the good side, the car runs fine without it. On the bad side, ebcu replacement is a ridiculously expensive repair. GM charges $1400 for the stupid part, the total was just under $2000 by the time all was done.----------- it would be one thing if the ebcu was some great invention that really improved the human condition. It is not.
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
Risk
This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
Remedy
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there CAN be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
Risk and remedy
Risk
During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
Remedy
Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.