Owners have filed 69 complaints about the 2000 GMC Yukon XL with NHTSA, the 14th highest of 28 Yukon XL years.
Most reports involve the brakes: 31 complaints, or 45% of everything filed, followed by fuel system (11) and tires (5). Half of those brakes reports describe a failure before 70,000 miles.
Complaints for this year mention 6 crashes and 7 injuries. These are owner reports and have not been verified by NHTSA.
NHTSA lists 6 recalls for this model year. The most recent, campaign 05V379000, was filed in August 2005 and concerns the antilock/traction control/electronic limited slip.
EPA figures put it at up to 14 MPG combined (12 city, 17 highway) in its most efficient version, out of 2 configurations tested, 3 MPG worse than the average SUV of 2000.
05V379000
Filed Aug 29, 2005 1,353,718 vehicles
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
- Risk
- This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
- Remedy
- Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 05068)
05V155000
Filed Apr 14, 2005 316,508 vehicles
Certain trucks and sport utility vehicles were built with fuel module reservoir assemblies that contain fuel pump wires connectors may overheat under certain operating conditions.
Risk and remedy
- Risk
- If the ignition circuit wire is exposed, the fuel pump fuse will blow, disabling the fuel pump and causing an engine stall or no-start condition. If sufficient heat is conducted to the pass-through connector, a hole in the connector may result, which may cause a 'service engine soon' light to be illuminated during the emission system diagnostic routine. Fuel vapor and in some cases liquid fuel may leak out of the fuel tank through the hole in the connector body. Fuel leakage, in the presence of an ignition source, could result in a fire. Also if the ignition circuit or ground wire is exposed and shorts to the fuel level sender card wires, inaccurate fuel level readings may result.
- Remedy
- Dealers will remove the fuel tank, and remove the module reservoir assemblies from the tank, and install a new service kit free of charge. An interim letter to owners was mailed on may 25, 2005. The owners were re-notified on october 19, 2005, since parts are now availabe. Owners may contact chevrolet AT 1-800-630-2438 and GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 05027)
Some pickup trucks, vans, and sport utility vehicles equipped with a hydraulic pump driveshaft that CAN fracture, resulting in immediate loss of hydraulic power steering assist. On certain vehicles equipped with hydro-boost power brakes, the same condition CAN result in loss of power assist for braking after the reserve pressure is depleted.
Risk and remedy
- Risk
- An inoperative pump CAN cause increased steering effort, and in hydro-boost equipped vehicles also increased braking effort, but does not completely eliminate the ability to steer or slow the vehicle.
- Remedy
- Dealers will replace the hydraulic pump. The campaign began on february 14, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 05001)