Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Dec 201388,900 milesTX
I started smelling gas in the car cabin. There was gas on my driveway as well. The gas sign started to flash on my dash and the check engine light came on. Went to the dealership and they said there was a major leak in the purge system. They quoted me $3066.88. They should take responsibility and not pass it on to me.
Owner complaint 10556255 filed with NHTSA
BrakesFiled Mar 2013120,000 milesTX
The warning light of brakes failure came on AT highway exit AT 65mph and the brake paddle hit the floor with no brakes. Pulled over and took the car to the dealer in mid March and was told by the dealer that this is the sbc pump that failed which would have been covered by mercedes benz under service bulletin no.: 484656 but the warranty expired on 02/28/13 and since I was 15 days over this will not be covered.
On certain vehicles, the sensotronic brake control (sbc) system may prematurely shift to the hydraulic back-up function mode, due to deterioration of the wiring harness connection, or due to premature failure of the hydraulic pump.
Risk and remedy
Risk
In the hydraulic back-up mode, the driver has braking power sufficient to stop the vehicle, although greater brake pedal pressure is required and the brake pedal travel will be noticeably longer.
Remedy
Dealers will install a bracket and replacement ground wire to the sbc pump unit on all vehicles free of charge. Additionally dealers will inspect and replace the sbc pump unit in sl vehicles produced during a limited production period. The recall began on august 8, 2005. Owners may contact mercedes-benz AT 1-800-367-6372.
Filed by
MERCEDES-BENZ USA, LLC. (manufacturer number 2005070007 & 2005110)
On certain vehicles, the electronic monitoring system of the sensotronic brake control (sbc) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacceptable pressure gradient is detected, the system will switch, as it is designed to do, into the hydraulic function mode.
Risk and remedy
Risk
If vehicles are not routinely serviced and have extremely high mileage combined with a high number of brake actuations, or a high brake actuation frequency, the pump motor of the sbc may run out of permissible tolerances, thereby triggering the hydraulic function mode.
Remedy
Dealers will inspect the sbc hydraulic unit, replacing it if necessary. The recall began on october 21m 2004. Owners should contact mercedes-benz AT 1-800-367-6372.
Filed by
MERCEDES-BENZ USA, LLC. (manufacturer number 2004050014)