Owners have filed 15 complaints about the 2004 Mercedes-Benz E-Class with NHTSA, the 8th highest of 16 E-Class years.
The fuel system draws the most complaints, 5 in all (33%), followed by transmission and drivetrain (3) and brakes (2). Half of those fuel system reports describe a failure before 80,000 miles.
Complaints for this year mention 2 crashes. These are owner reports and have not been verified by NHTSA.
NHTSA lists 4 recalls for this model year. The most recent, campaign 08V303000, was filed in July 2008 and concerns the electrical system.
EPA figures put it at up to 20 MPG combined (17 city, 24 highway) in its most efficient version, out of 9 configurations tested, close to the average midsize car of its year.
Mercedes-benz is recalling my 2006-2008 m-class, r-class, my 2005-2009 slk-class, my 2005-2008 c-class, my 2003-2004 and 2006-2008 clk-class, my 2003-2008 e-class, my 2004 and 2008 cl-class, my 2008 cls-class, my 2004 and 2007-2008 s-class, my 2003 g-class, and my 2003-2004, 2006 and 2009 sl-class vehicles. A software calibration number (scn) coding received on the affected vehicles during a recent workshop visit was incorrect. Depending on the model year and model affected, the results of an incorrect scn coding CAN affect a number of vehicle safety and emission functions including the following types of functions: (1) the fuel gauge readings may be incorrect; (2) a stuck fuel-level sensor may not be displayed in the instrument cluster; (3) the OBD system may cause the check engine light to illuminate incorrectly; and, (4) the speedometer may be out of tolerance.
Risk and remedy
- Risk
- In the event of a vehicle crash, the electrical fuel pump may not receive a crash signal that is required for the fuel pump to disconnect and prevent future fuel delivery as designed.
- Remedy
- Dealers will recode the scn free of charge. The recall began on august 30, 2008. Owners may contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2008 070001)
On certain vehicles, the sensotronic brake control (sbc) system may prematurely shift to the hydraulic back-up function mode, due to deterioration of the wiring harness connection, or due to premature failure of the hydraulic pump.
Risk and remedy
- Risk
- In the hydraulic back-up mode, the driver has braking power sufficient to stop the vehicle, although greater brake pedal pressure is required and the brake pedal travel will be noticeably longer.
- Remedy
- Dealers will install a bracket and replacement ground wire to the sbc pump unit on all vehicles free of charge. Additionally dealers will inspect and replace the sbc pump unit in sl vehicles produced during a limited production period. The recall began on august 8, 2005. Owners may contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2005070007 & 2005110)
04V296000
Filed Jun 22, 2004 143,387 vehicles
On certain vehicles, the electronic monitoring system of the sensotronic brake control (sbc) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacceptable pressure gradient is detected, the system will switch, as it is designed to do, into the hydraulic function mode.
Risk and remedy
- Risk
- If vehicles are not routinely serviced and have extremely high mileage combined with a high number of brake actuations, or a high brake actuation frequency, the pump motor of the sbc may run out of permissible tolerances, thereby triggering the hydraulic function mode.
- Remedy
- Dealers will inspect the sbc hydraulic unit, replacing it if necessary. The recall began on october 21m 2004. Owners should contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2004050014)