Owners of the 2010 Mercury Milan have reported 107 brakes problems to NHTSA, 11% of all complaints about this model year.
Where owners named a specific part, the most common were pedals and linkages (1).
The typical report came at around 76,000 miles, and complaints were filed between July 2012 and September 2025.
These brakes complaints include 8 crashes and 2 injuries.
For comparison, the 2008 Milan has the most brakes complaints of any year, with 198.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Complaints107
Typical mileage76k
Crashes / fires8 / 0
Injuries2
Parts named in these complaints
Pedals And Linkages1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 2025WA
The safety recall 19S54 is affecting my vehicle. It was made at the same plant at the approved date range as the other vehicles on the recall list but it seems my vehicle wasnt added to the list because it is a hybrid but it has the same exact issue as the non hybrid models
Owner complaint 11689311 filed with NHTSA
BrakesFiled Jul 2025140,000 milesTN
The contact owns a 2010 Mercury Milan. The contact stated that while depressing the brake pedal to the floorboard, the vehicle failed to immediately stop. The vehicle was taken to the local brake service center, but the cause of the failure was not yet determined, and the vehicle was not yet repaired. The manufacturer was notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 19V904000 (SERVICE BRAKES, HYDRAULIC). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was approximately 140,000.
Owner complaint 11671729 filed with NHTSA
BrakesFiled Jan 2025MI
Whenever the car engine isn't warm and I slam on the brakes, they barely respond. I have replaced the master cylinder, abs hydraulic module, brake booster, calipers, pads, and rotors, and it still has about 20% normal braking power when the engine is cold. Just got it back from the dealership again. Dealer said no vacuum leak found, no leaks found, abs module checks out fine, and said the check valve passed diagnostics. The problem remains. This has been ongoing for several years now. May have contributed to an accident in 2023. Not sure as my wife was driving. When the engine is warm, the brakes work perfectly.
Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.
Risk and remedy
Risk
If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.
Remedy
Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S54.