Owners of the 1999 Mercury Sable have reported 20 seat belt problems to NHTSA, 8% of all complaints about this model year.
Where owners named a specific part, the most common were front (15) and rear/other (1).
The typical report came at around 75,000 miles, and complaints were filed between May 1999 and August 2012.
These seat belt complaints include 1 crash and 4 injuries.
For comparison, the 1997 Sable has the most seat belt complaints of any year, with 21.
Belts, buckles, retractors, pretensioners and anchorages.
2 recalls for this model year involve the seat belt.
If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage75k
Crashes / fires1 / 0
Injuries4
Parts named in these complaints
Front15
Rear/Other1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Seat beltsFiled Aug 2012125,000 milesNY
Tl* the contact owns a 1999 Mercury Sable. The contact stated that the passenger seat belt does not retract or properly secure the passenger. The manufacturer stated that the VIN was not included in (NHTSA campaign ID number: 99v250000 seat belts: front: anchorage); the vehicle was not repaired. The approximate failure mileage was 125,000. The current mileage was not available.
Owner complaint 10473148 filed with NHTSA
Seat beltsFiled Jun 201098,000 milesIL
Tl* the contact owns a 1999 Mercury Sable. The contact stated that while attempting to operate the vehicle she noticed the front passenger side seat belt was stuck in the anchorage and would not pull out or retract. The vehicle was taken to an authorized dealer where the contact was informed the vehicle was not included in the recall associated with NHTSA campaign ID number: 99v250000 (seat belts: front: anchorage). The vehicle was not serviced for the failure. The failure and current mileages were 98,000. Updated 10/27/10.
Vehicle description: passenger vehicles. The seat belt retractor may have a pin shaft in the switchable elr/alr mechanism that is incorrectly formed. In some circumstances, the switching mechanism could become nonfunctional, preventing the seat belt webbing from being extracted from the retractor. It is also possible that malfunction of the mechanism could prevent the belt from being switched into the alr mode. The elr mechanism is not affected by this condition.
Risk and remedy
Risk
If the mechanism malfunctions and does not allow the webbing to be extracted, the lap and shoulder belt could not be worn by a vehicle occupant. In the event that the mechanism does not allow the alr mode to be engaged, the operator may be unable to properly install a child seat in that seating position.
Remedy
Dealers will inspect the lap and shoulder belt assemblies. Assemblies with julian date codes of 200 through 223 are suspect and will be replaced.
Vehicle description: passenger vehicles equipped with manual seat tracks. The front seat belt buckle attaching stud may have been improperly heat treated. This heat treatment may have resulted in cracks developing in the stud.
Risk and remedy
Risk
If the stud is cracked, in the event of a vehicle crash, the occupant may not be properly restrained, increasing the risk of personal injury.
Remedy
Dealers will replace the seat belt buckle mounting bracket and stud assembly.