Owners of the 2001 Mercury Sable have reported 12 seat belt problems to NHTSA, 3% of all complaints about this model year.
Where owners named a specific part, the most common were front (7).
The typical report came at around 52,000 miles, and complaints were filed between March 2001 and September 2013.
For comparison, the 1997 Sable has the most seat belt complaints of any year, with 21.
Belts, buckles, retractors, pretensioners and anchorages.
2 recalls for this model year involve the seat belt.
If your problem matches, a dealer repairs it free under the recall.
Complaints12
Typical mileage52k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Front7
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Seat beltsFiled Sep 201383,000 milesFL
The drivers seat belt does not latch (lock) properly. The belt has on numerous occasions became unfastened when driving. The drivers belt also does not retract after use.
Owner complaint 10545555 filed with NHTSA
Seat beltsFiled May 2012MN
I own a 2001 Mercury Sable. AT approximately 70,000 the driver's seat belt began to retract sporadically. AT about 75,000 miles the seatbelt no longer retracted AT all. The seatbelt still locks when pressure is put on it, but I AM concerned about its safety.
Vehicle description: passenger cars. The seat belt buckle tongue may not fully eject from the buckle assembly when the release button is pushed slowly. This condition could also result in a partial latch of the tongue in the buckle.
Risk and remedy
Risk
In the event of a vehicle crash, the vehicle occupant may not be properly restrained, possibly resulting in personal injury or death.
Remedy
Dealers will replace the driver and right front passenger seat belt buckles. Owner notification began may 4, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
Vehicle description: passenger vehicles. The child safety seat anchor latch (iso-fix anchor) fasteners do not have adequate residual torque. The anchors are secured to the floor pan with a reinforcement plate that has two studs that extend upward through the floor pan and the iso-fix anchor. The sealer on the floor pan could cause a soft joint and, even if the nuts are properly torqued, road vibrations could cause the nut to work its way completely off the stud.
Risk and remedy
Risk
The anchor may not hold the child safety seat in position during an accident, increasing the risk of injury to the occupant of the child safety seat.
Remedy
Dealers will remove and re-install the bracket nut using a torque retention material (red loctite). Owner notification began september 11, 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.