Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 2025NC
With my vehicle the brakes go straight to the floor. I took it to the mitsubishi dealership closest to me (Bobmills mitsubishi Jacksonville Nc). When I got there i told them what was going on, and if you bleed the brakes they worked fine for 3 or 4 days but after that the brakes would just go to the floor again. They said they bleed the brakes to replace the fluid and then tested the ABS module for a recall and said it was fine but I had a collapsed brake line in the rear. I replaced all the brake lines on the vehicle and did a complete bleed again to remove any air. The brakes now go all the way to the floor again.
Owner complaint 11690570 filed with NHTSA
BrakesFiled Oct 2022SC
Brakes consistently fail to hold pressure and are letting go. I purchased this car back in April and the previous owner had no idea of the recall. Did a bit of research and found it's a defect in the system. Once the car fails to hold pressure I have to very rapidly spam the break pedal to get a sliver of pressure so my car can come to a stop. Breaking with little pressure grinds the brakes and doesn't stop the car.
Owner complaint 11488426 filed with NHTSA
BrakesFiled Nov 20201,171,000 milesIN
Vehicle is for sale sitting on napleton hyundai of carmel's used car lot, 4200 east 96th street indianapolis,in 46240. I just paid for and signed paperwork for an 2007 Mitsubishi Eclipse SE, I haven't taken ownership as far a driving it off lot after pay/sign. Car fax was shown to me b4 signing, it's been 2 days and I haven't taken off lot yet (front d side caliper bracket slide/glide pins are seized up, brake pads locked onto rotor. I will not drive car until dealer completes recall.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2009 Eclipse vehicles manufactured April 20, 2005, to February 13, 2009, and 2007-2009 Eclipse Spyder vehicles manufactured December 23, 2005, to February 13, 2009. Due to corrosion inside the antil-lock brake system (ABS) unit, one or more of the internal valves may seize. In a braking event that uses the ABS, a seized valve would increase brake pedal travel and reduce braking ability.
Risk and remedy
Risk
A sudden reduction of braking performance may increase the risk of a crash.
Remedy
MMNA will notify owners, and dealers will inspect, flush and clean the ABS hydraulic unit using high grade brake fluid, free of charge. If the inspection shows that the valves may seize, the ABS unit will be replaced. The recall began on July 21, 2015. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-15-004.
Filed by
Mitsubishi Motors North America, Inc. (manufacturer number SR-15-004)