Owners have filed 107 complaints about the 2007 Mitsubishi Eclipse with NHTSA, the 9th highest of 23 Eclipse years.
Most reports involve the brakes: 87 complaints, or 81% of everything filed, followed by air bags (9) and body and structure (5). Half of those brakes reports describe a failure before 84,000 miles.
Complaints for this year mention 15 crashes, 1 fire, 13 injuries, and 1 death. These are owner reports and have not been verified by NHTSA.
NHTSA lists 4 recalls for this model year. The most recent, campaign 15V337000, was filed in June 2015 and concerns the control unit/module.
EPA figures put it at up to 23 MPG combined (20 city, 28 highway) in its most efficient version, out of 4 configurations tested, close to the average subcompact car of its year.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2009 Eclipse vehicles manufactured April 20, 2005, to February 13, 2009, and 2007-2009 Eclipse Spyder vehicles manufactured December 23, 2005, to February 13, 2009. Due to corrosion inside the antil-lock brake system (ABS) unit, one or more of the internal valves may seize. In a braking event that uses the ABS, a seized valve would increase brake pedal travel and reduce braking ability.
Risk and remedy
- Risk
- A sudden reduction of braking performance may increase the risk of a crash.
- Remedy
- MMNA will notify owners, and dealers will inspect, flush and clean the ABS hydraulic unit using high grade brake fluid, free of charge. If the inspection shows that the valves may seize, the ABS unit will be replaced. The recall began on July 21, 2015. Owners may contact MMNA customer service at 1-888-648-7820. MMNA's number for this recall is SR-15-004.
- Filed by
- Mitsubishi Motors North America, Inc. (manufacturer number SR-15-004)
Mitsubishi is recalling 45,988 my 2005-2007 endeavor, galant, eclipse coupe, and my 2007 eclipse spyder vehicles. The bracket that is the attachment point for the left rear fuel tank mounting strap may have been improperly formed during a metal stamping process. The process may have caused the metal to have a split in the area where the bolt that holds one of the two fuel tank straps to the underside of the vehicle is located. In the event the fuel tank is full and the vehicle is subject to a severe collision, the bracket may break and allow the fuel tank to drop down, possibly causing a fuel leak.
Risk and remedy
- Risk
- Fuel leakage in the presence of an ignition source could result in a fire.
- Remedy
- Dealers will inspect to see if the left rear fuel tank strap mounting bracket has splitting beyond a specific limit. Vehicles with moderate to severe splitting will be repaired using a reinforcement cap, a special structural adhesive, and a rivet to reinforce the fuel tank mounting bracket. The recall began on september 20, 2008. Owners may contact mitsubishi AT 1-800-222-0037.
- Filed by
- MITSUBISHI MOTORS NORTH AMERICA, INC. (manufacturer number SR-08-005)
On certain vehicles equipped with automatic transmissions, the key lock cable was improperly manufactured and may not allow the cable end to lock into the floor shifter mechanism. This CAN result in the interlock system to become inoperative and allow the ignition key to be removed without the gearshift mechanism being placed in the park position.
Risk and remedy
- Risk
- If the driver does not shift to park before removing the key and fails to engage the parking brake, the vehicle could roll and a crash could occur.
- Remedy
- Dealers will inspect the ignition interlock cable and replace it if necessary. The recall began on november 20, 2006. Owners may contact mitsubishi AT 1-888-648-7820.
- Filed by
- MITSUBISHI MOTORS NORTH AMERICA, INC. (manufacturer number SR-06-005)