Oldsmobile · Cutlass Supreme

1997 Oldsmobile Cutlass Supreme Steering Problems

Midsize car · FWD · Regular

Owners of the 1997 Oldsmobile Cutlass Supreme have reported 14 steering problems to NHTSA, 33% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (10), hydraulic power assist (1), and gear box (other than rack and pinion) (1).

The typical report came at around 45,000 miles, and complaints were filed between December 1997 and June 2004.

These steering complaints include 2 crashes and 1 injury.

No other Cutlass Supreme year has as many steering complaints.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints14
Typical mileage45k
Crashes / fires2 / 0
Injuries1

Parts named in these complaints

  • Rack And Pinion10
  • Hydraulic Power Assist1
  • Gear Box (Other Than Rack And Pinion)1
  • Hydraulic Power Assist System1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Apr 2004 45,000 miles WV

Recall 03v527000 concerning steering gear bearings failure. Consumer was authorized to take the vehicle to a chevrolet dealership to have recall repairs done. The dealer informed the consumer that a leaking rack and pinion needed to be replaced before recall work could be done. Replacement of the rack and pinion was part of the recalled problem. Dealer charged the consumer for replacing the rack and pinion. *ak the consumer requested reimbursement. The transmission cable from the gear shift lever had to be replaced

Owner complaint 10059847 filed with NHTSA
Steering Filed Feb 2004 60,000 miles MI Crash

While driving vehicle pulled to the right. Consumer pulled the steering wheel to the left and the vehicle rolled over and went into a ditch. Vehicle was totaled.

Owner complaint 10059497 filed with NHTSA

Related recalls

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

Steering complaints across Cutlass Supreme years

Questions about steering problems

How common are steering problems on the 1997 Oldsmobile Cutlass Supreme?

14 owners have reported steering problems to NHTSA, 33% of all complaints for this model year.

Is there a recall for steering problems on the 1997 Oldsmobile Cutlass Supreme?

Yes. 1 recall for this model year concerns the steering: 03V527000.