Oldsmobile · Cutlass Supreme

1996 Oldsmobile Cutlass Supreme Steering Problems

Midsize car · FWD · Regular

Owners of the 1996 Oldsmobile Cutlass Supreme have reported 5 steering problems to NHTSA, 11% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (2), steering wheel/handle bar (1), and hydraulic power assist system (1).

The typical report came at around 68,000 miles, and complaints were filed between September 2002 and April 2004.

For comparison, the 1997 Cutlass Supreme has the most steering complaints of any year, with 14.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileage68k
Crashes / fires0 / 0
Injuries0

Parts named in these complaints

  • Rack And Pinion2
  • Steering Wheel/Handle Bar1
  • Hydraulic Power Assist System1
  • Column Locking1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Apr 2004 FL

The consumer is disabled which precludes her from driving 30-40 miles to the nearest Oldsmobile dealer to have the vehicle repaired. The vehicle was included in a rack and pinion recall and the consumer wanted to take the vehicle the nearest chevrolet dealer to have it repaired. The consumer was informed by the chevrolet dealer's service dept that the repairs could not be done there.

Owner complaint 10067471 filed with NHTSA
Steering Filed Feb 2004 IL

While turning the steering wheel towards the right it locked up and caused the consumer to lose control of the vehicle. The vehicle was taken to the dealer to be inspected. Please provide any additional information. *nm the consumer was informed the problem was due to a defective rack and pinion as stated in the recall.

Owner complaint 10055254 filed with NHTSA

Related recalls

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

Steering complaints across Cutlass Supreme years

Questions about steering problems

How common are steering problems on the 1996 Oldsmobile Cutlass Supreme?

5 owners have reported steering problems to NHTSA, 11% of all complaints for this model year.

Is there a recall for steering problems on the 1996 Oldsmobile Cutlass Supreme?

Yes. 1 recall for this model year concerns the steering: 03V527000.