There are 6 safety recalls on file for the 1991 Oldsmobile Cutlass,
filed between January 1992 and July 2000.
Each one is repaired free by a franchised Oldsmobile dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 Cutlass is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2000 (1)
00V189000
Filed Jul 11, 2000 713,435 vehicles
Vehicle description: passenger vehicles originally sold or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, where road salt use is heavy. A condition where one or both front engine cradle bolts CAN pull through the retainers due to corrosion of the retainers.
Risk and remedy
- Risk
- If both bolts pull through, the front of the cradle would no longer be supported AT the mounting locations and the steering intermediate shaft could separate from the steering gear.
- Remedy
- Dealers will replace the front and rear frame/cradle bolts and retainers.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00061/00065)
1997 (1)
Vehicle description: passenger vehicles and mini vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to corrosion of the retainer. If both bolts pull through, the rear cradle would not longer be supported AT these mounting locations and the steering intermediate shaft CAN separate from the steering gear.
Risk and remedy
- Risk
- If this were to occur while the vehicle was in motion, a vehicle crash could result.
- Remedy
- Dealers will replace the rear cradle bolts and retainers.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 97016)
1995 (1)
95V173000
Filed Sep 15, 1995 2,216,325 vehicles
These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages."
Risk and remedy
- Risk
- Consequence of non-compliance: in a collison, stress CAN cause the attachment metal to tear and allow the anchorage to separate from the body of the vehicle. The safety belt may not protect an occupant in the event of a vehicle crash.
- Remedy
- Dealers will replace the existing anchor bolts with a new shoulder bolt and thread locking adhesive. Additionally, noise control patches will be applied AT each anchorage.
- Filed by
- GENERAL MOTORS CORP.
1992 (3)
The power seat or recliner wiring harness CAN be pinched or CAN chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.
Risk and remedy
- Risk
- The high current caused by the electrical short welds thecircuit breaker elements together in the closed position, leaving the circuitunprotected and generating sufficient heat to burn the wire insulation andignite the seat cushion material.
- Remedy
- Repair any abraded wiring and reroute the wiring harness using a wiring harness clip.
- Filed by
- GENERAL MOTORS CORP.
Moisture CAN enter the express-down electronic control module and cause a short circuit that causes window operation without operator control, and leaves the window in the down position.
Risk and remedy
- Risk
- The electronic control module will fail from overheatingand could result in a fire hazard inside the door panel.
- Remedy
- Replace the window express-down electronic control module.
- Filed by
- GENERAL MOTORS CORP.
92V003000
Filed Jan 10, 1992 347,866 vehicles
The front door shoulder belt guide loops may be cracked and are not in compliance with fmvss 208.
Risk and remedy
- Risk
- The seat occupant faces increased risk of injury in theevent of a sudden stop or accident.
- Remedy
- Install reinforcing plates on the cracked shoulder belt guides.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1991 Oldsmobile Cutlass have?
NHTSA lists 6 recalls for the 1991 Oldsmobile Cutlass.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.