Oldsmobile · Cutlass

1991 Oldsmobile Cutlass

Midsize car · FWD · Regular

Owners have filed 193 complaints about the 1991 Oldsmobile Cutlass with NHTSA, more than any other Cutlass model year on record.

The brakes draws the most complaints, 60 in all (31%), followed by engine (30) and seat belts (26). Half of those brakes reports describe a failure before 80,000 miles.

Complaints for this year mention 11 crashes, 8 fires, and 13 injuries. These are owner reports and have not been verified by NHTSA.

NHTSA lists 6 recalls for this model year. The most recent, campaign 00V189000, was filed in July 2000 and concerns the structure.

EPA figures put it at up to 24 MPG combined (21 city, 30 highway) in its most efficient version, out of 16 configurations tested, 5 MPG better than the average midsize car of 1991.

What owners report

Full breakdown
00V189000 Filed Jul 11, 2000 713,435 vehicles

Structure

Vehicle description: passenger vehicles originally sold or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, where road salt use is heavy. A condition where one or both front engine cradle bolts CAN pull through the retainers due to corrosion of the retainers.

Risk and remedy
Risk
If both bolts pull through, the front of the cradle would no longer be supported AT the mounting locations and the steering intermediate shaft could separate from the steering gear.
Remedy
Dealers will replace the front and rear frame/cradle bolts and retainers.
Filed by
GENERAL MOTORS CORP. (manufacturer number 00061/00065)
97V058000 Filed Apr 8, 1997 676,535 vehicles

Structure

Vehicle description: passenger vehicles and mini vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to corrosion of the retainer. If both bolts pull through, the rear cradle would not longer be supported AT these mounting locations and the steering intermediate shaft CAN separate from the steering gear.

Risk and remedy
Risk
If this were to occur while the vehicle was in motion, a vehicle crash could result.
Remedy
Dealers will replace the rear cradle bolts and retainers.
Filed by
GENERAL MOTORS CORP. (manufacturer number 97016)
95V173000 Filed Sep 15, 1995 2,216,325 vehicles

Anchorage

These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages."

Risk and remedy
Risk
Consequence of non-compliance: in a collison, stress CAN cause the attachment metal to tear and allow the anchorage to separate from the body of the vehicle. The safety belt may not protect an occupant in the event of a vehicle crash.
Remedy
Dealers will replace the existing anchor bolts with a new shoulder bolt and thread locking adhesive. Additionally, noise control patches will be applied AT each anchorage.
Filed by
GENERAL MOTORS CORP.

Recent owner reports

Complaints as owners filed them with NHTSA, lightly tidied for readability. They are not verified.

Speed control Filed Apr 2011 200,000 miles NY

Tl* the contact owns a 1991 Oldsmobile Cutlass supreme. The contact was traveling 50 MPH when the accelerator pedal was depressed to the floorboard abnormally. The brakes were engaged but the vehicle did not respond. The contact stated that the vehicle accelerated to 85 MPH before the contact turned the vehicle off. The contact had to wait a few minutes before restarting the vehicle as the vehicle resumed normal operation. The vehicle was not inspected or repaired for the failure. The failure and current mileage was 200,000.

Owner complaint 10397375 filed with NHTSA
Seat belts Filed Nov 2010 60,000 miles VA

Tl*the contact owns a 1991 Oldsmobile ciera. The contact was concerned about a recall campaign number is 95v173000, seat belts front, anchorage on his year, make and model vehicle. The, contact had not had any problems with the seat belt, but was concerned that it could fail in the event of a crash. The failure and current mileages were 60000. Updated 01/24/11 *bf updated 03.22.11

Owner complaint 10367244 filed with NHTSA
Body and structure Filed May 2008 99,132 miles CO

Tl*the contact owns a 1991 Oldsmobile Cutlass ciera. The contact took his vehicle to be inspected by a dealer because he was experiencing failure with the wheel bearings. He was informed that the motor mount was loose. The vehicle was repaired and the contact was later informed of NHTSA campaign ID number 00v189000 (engine and engine cooling). His VIN was not included in the recall. The VIN was unknown. The current mileage was 105,632 and failure mileage was 99,132. Updated 06/09/2008.

Owner complaint 10227569 filed with NHTSA
24
21city
30highway
24combined MPG
$2,800fuel a year

Most efficient of 16 EPA-tested configurations. Average for 1991 midsize cars: 19.5 MPG.

How 1991 compares with other Cutlass years

Owner complaints per model year. The highlighted column is this year.

Questions about the 1991 Oldsmobile Cutlass

Does the 1991 Oldsmobile Cutlass have any recalls?

Yes. NHTSA lists 6 recalls for the 1991 Oldsmobile Cutlass, most recently 00V189000 (July 2000) for the structure.

What are the most common problems with the 1991 Oldsmobile Cutlass?

Owner complaints to NHTSA most often involve the brakes (60), engine (30), and seat belts (26).

What gas mileage does the 1991 Oldsmobile Cutlass get?

The EPA rates it at 21 MPG city, 30 MPG highway and 24 MPG combined for its most efficient version.