Oldsmobile · Cutlass

1997 Oldsmobile Cutlass Steering Problems

Midsize car · FWD · Regular

Owners of the 1997 Oldsmobile Cutlass have reported 20 steering problems to NHTSA, 21% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (13), hydraulic power assist system (4), and hydraulic power assist (2).

The typical report came at around 80,000 miles, and complaints were filed between January 1998 and January 2014.

These steering complaints include 2 crashes and 1 injury.

For comparison, the 1998 Cutlass has the most steering complaints of any year, with 21.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage80k
Crashes / fires2 / 0
Injuries1

Parts named in these complaints

  • Rack And Pinion13
  • Hydraulic Power Assist System4
  • Hydraulic Power Assist2

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Jan 2014 200,000 miles CA

Vechile recently started making groaning noise when steering and from power steering pump. Power steering pump was replace back in 2011. Took to goodyear and tech indicated pump was fine, problem point to the rack and pinion.

Owner complaint 10559086 filed with NHTSA
Steering Filed Oct 2013 60,000 miles KY

We bought the car in 2010 from a used car dealer. Upon 6 months of driving we noticed a steering problem that was hard to the left and just didn't seem right. The engine also had overheating and gasket problems so we had the engine replaced. Upon test driving the vehicle the mechanic was driving and the power steer had a complete failure and ran him towards oncoming traffic and then back another direction. Upon return to the shop he concluded the entire rack was broken and needed replaced.

Owner complaint 10548733 filed with NHTSA

Related recalls

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

Steering complaints across Cutlass years

Questions about steering problems

How common are steering problems on the 1997 Oldsmobile Cutlass?

20 owners have reported steering problems to NHTSA, 21% of all complaints for this model year.

Is there a recall for steering problems on the 1997 Oldsmobile Cutlass?

Yes. 1 recall for this model year concerns the steering: 03V527000.