Oldsmobile · Cutlass

1998 Oldsmobile Cutlass Steering Problems

Midsize car · FWD · Regular

Owners of the 1998 Oldsmobile Cutlass have reported 21 steering problems to NHTSA, 14% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (9), hydraulic power assist (2), and hydraulic power assist system (2).

The typical report came at around 66,000 miles, and complaints were filed between October 1998 and August 2013.

No other Cutlass year has as many steering complaints.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints21
Typical mileage66k
Crashes / fires0 / 0
Injuries0

Parts named in these complaints

  • Rack And Pinion9
  • Hydraulic Power Assist2
  • Hydraulic Power Assist System2
  • Steering Wheel/Handle Bar1
  • Column Locking1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Aug 2013 141,000 miles IA

Frame, where steering rack bolts to, rusted out. Steering rack became separated from the frame causing a dangerous steering condition. Frame needs to be replaced AT a very high cost.

Owner complaint 10537788 filed with NHTSA
Steering Filed Feb 2009 66,051 miles AL

Tl*the contact owns a 1998 Oldsmobile Cutlass. The contact stated that the steering wheel would tighten when making right and left turns. He received a recall letter pertaining to the steering rack and pinion, which stated that the lower pinion bearings in the power rack and pinion assembly were not crimped properly. This is where the retainer tabs were located. The failure could allow the ball bearings to escape. The dealer repaired the vehicle according to NHTSA campaign ID number 03v527000 (steering:rack and pinion); however, the contact felt no change in the vehicle.

Owner complaint 10257421 filed with NHTSA

Related recalls

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

Steering complaints across Cutlass years

Questions about steering problems

How common are steering problems on the 1998 Oldsmobile Cutlass?

21 owners have reported steering problems to NHTSA, 14% of all complaints for this model year.

Is there a recall for steering problems on the 1998 Oldsmobile Cutlass?

Yes. 1 recall for this model year concerns the steering: 03V527000.