Oldsmobile · Silhouette

1997 Oldsmobile Silhouette Steering Problems

Special purpose vehicle · FWD · Regular

Owners of the 1997 Oldsmobile Silhouette have reported 20 steering problems to NHTSA, 19% of all complaints about this model year.

Where owners named a specific part, the most common were rack and pinion (8), hydraulic power assist system (6), and column locking (4).

The typical report came at around 9,000 miles, and complaints were filed between July 1997 and May 2004.

No other Silhouette year has as many steering complaints.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

1 recall for this model year involves the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage9k
Crashes / fires0 / 0
Injuries0

Parts named in these complaints

  • Rack And Pinion8
  • Hydraulic Power Assist System6
  • Column Locking4
  • Hydraulic Power Assist2
  • Steering Wheel/Handle Bar1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed May 2004 9,000 miles OH

When turning the vehicle off, the horn continuously sounded and all the doors automatically locked. The doors could not be manually opened. The consumer had to turn the vehicle on and wait for a period of five to ten minutes and then turn the vehicle off to get out of the vehicle. Also, power steering fluid had to be added every 10,000 miles and the vehicle overheated due to faulty gaskets. The engine had been replaced twice.

Owner complaint 10064708 filed with NHTSA
Steering Filed Mar 2003 TX

The consumer received a recall letter regarding the rack and pinion, an appointment was made, however the day before the appointment, consumer received a call from the dealer who stated they had no tools to correct the problem.

Owner complaint 10014639 filed with NHTSA

Related recalls

02V286000 Filed Nov 4, 2002 1,159,156 vehicles

Rack and pinion

Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.
Filed by
GENERAL MOTORS CORP. (manufacturer number 02049)

Steering complaints across Silhouette years

Questions about steering problems

How common are steering problems on the 1997 Oldsmobile Silhouette?

20 owners have reported steering problems to NHTSA, 19% of all complaints for this model year.

Is there a recall for steering problems on the 1997 Oldsmobile Silhouette?

Yes. 1 recall for this model year concerns the steering: 02V286000.