Owners have filed 104 complaints about the 1997 Oldsmobile Silhouette with NHTSA, the 4th highest of 15 Silhouette years.
The steering draws the most complaints, 20 in all (19%), followed by lights (18) and body and structure (14). Half of those steering reports describe a failure before 9,000 miles.
Complaints for this year mention 4 crashes and 1 injury. These are owner reports and have not been verified by NHTSA.
NHTSA lists 6 recalls for this model year. The most recent, campaign 04V597000, was filed in December 2004 and concerns the doors latch.
EPA figures put it at up to 19 MPG combined (16 city, 23 highway), 2 MPG better than the average special purpose vehicle of 1997.
04V597000
Filed Dec 22, 2004 717,302 vehicles
On certain minivans equipped with second-row bucket seats or captain's chairs and a power sliding door on the passenger side of the vehicle, a passenger using the interior handle to open the power sliding door could be injured.
Risk and remedy
- Risk
- If a passenger uses the interior handle to open the power sliding door and holds onto the handle while it is being opened by the motor, the passenger's arm may be pushed into the seat back or armrest and a wrist or lower arm injury may result.
- Remedy
- Dealers will replace the power sliding door interior handle on the passenger-side. If the vehicle is equipped with a power or manual sliding door on the driver-side, the interior handle will also be replaced for appearance reasons. Note: before the vehicle is serviced, GM advises owners to not use the interior door handle to open the door. The driver CAN open and close the door from switches AT the driver's position or by using the remote key fob. The driver should tell passengers to use the switch located in front of the door to open or close it. The driver should use the override switch to prevent operation of the power door by children or by others who are not familiar with its use. The owner notification letter mailing will be conducted in phases with the first phase beginning on may 31, 2005. The second phase mailing began on july 18, 2005. The recall began on may 31, 2005. Phase 2 began on july 18, 2005. Phase 3 (final phase) began on august 24, 2005, to all remaining customers. Owners should contact chevrolet AT 1-800-630-2438; pontiac AT 1-800-620-7668; or oldsmobile AT 1-800-630-6537.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 04110)
02V286000
Filed Nov 4, 2002 1,159,156 vehicles
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Risk and remedy
- Risk
- If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
- Remedy
- Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 02049)
01V264000
Filed Aug 21, 2001 248,737 vehicles
Vehicle description: 1997-2001 chevrolet venture, pontiac montana/transport, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from april to august 2001. Also 2001 chevrolet venture, pontiac montana, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors assembled in january through april 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator CAN jam in the unlatched position and, when the sliding door closes, it will not be latched.
Risk and remedy
- Risk
- If this happens, the power sliding door CAN open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the van and be injured.
- Remedy
- Dealers will inspect and, if required, install a new power sliding door unlatch actuator assembly. Owner notification began on october 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 01059)