Plymouth · Voyager

1991 Plymouth Voyager Body and structure Problems

Special purpose vehicle · 4WD/AWD, FWD · Regular

Owners of the 1991 Plymouth Voyager have reported 70 body problems to NHTSA, 13% of all complaints about this model year.

Where owners named a specific part, the most common were body (70) and frame and members (2).

The typical report came at around 144,000 miles, and complaints were filed between January 1995 and September 2010.

These body complaints include 4 crashes, 1 fire, 6 injuries, and 1 death.

For comparison, the 1992 Voyager has the most body complaints of any year, with 77.

Doors, hoods, frames, bumpers, sunroofs, glass mounting and body panels, including rust-through and structural cracks.

1 recall for this model year involves the body. If your problem matches, a dealer repairs it free under the recall.
Complaints70
Typical mileage144k
Crashes / fires4 / 1
Injuries6

Parts named in these complaints

  • Body70
  • Frame And Members2

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Body and structure Filed Sep 2010 185,102 miles NY

Tl*the contact owns a 1991 Plymouth Voyager. The contact stated the bolt that held the strut on the passenger side of the liftgate fractured as it was closing. The contact stated that the liftgate was no longer operable. The contact received notification of NHTSA campaign ID number: 99v213000 (structure:body:hatchback/liftgate:hinge and attachments) in 1999 but had never received the recall repair. The contact took the vehicle to the dealer and the repair was refused. The manufacturer advised that due to the age of the recall, the contact would be liable for one half of the repair costs.

Owner complaint 10355194 filed with NHTSA
Body and structure Filed Jan 2004 80,000 miles CA

Vehicle has been a source of numerous never seen before and unresolved problems especially due to the fact that it is presently located in provence (france) where parts and labor are very hard to come by.....

Owner complaint 10068919 filed with NHTSA
Body and structure Filed Mar 2002 FL

Rubber plastic mounting is melting around area of license plate. Melting CAN cause a potential fire. Dealer states that material is too heat sensitive. Problem is being repaired for second time. Dealer was notified. *ak consumer states that the wiring harness to license plate lights had melted AT bulb sockets. Sockets no longer attached to tailgate.

Owner complaint 8006101 filed with NHTSA

Related recalls

99V213000 Filed Sep 2, 1999 1,318,189 vehicles

Hinge and attachments

Vehicle description: mini vans. The bolts used to attach the strut to the body and the rear liftgate CAN accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt CAN fail.

Risk and remedy
Risk
Personal injury could occur if the bolts break allowing the liftgate to fall suddenly.
Remedy
Dealers will inspect for loose fasteners, if the fasteners are loose, the strut (and integral bolts) will be replaced. If the bolt shows evidence of torque, the bolt will be removed, larger washers will replace the existing washer and the bolt will be reinstalled and hand tightened to the target torqued.
Filed by
DAIMLERCHRYSLER CORPORATION

Body and structure complaints across Voyager years

Questions about body and structure problems

How common are body and structure problems on the 1991 Plymouth Voyager?

70 owners have reported body and structure problems to NHTSA, 13% of all complaints for this model year.

Is there a recall for body and structure problems on the 1991 Plymouth Voyager?

Yes. 1 recall for this model year concerns the body: 99V213000.