Owners of the 1991 Plymouth Voyager have reported 149 brakes problems to NHTSA, 29% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (120), foundation components (28), and power assist (2).
The typical report came at around 94,000 miles, and complaints were filed between January 1995 and June 2010.
These brakes complaints include 4 crashes and 1 injury.
For comparison, the 1993 Voyager has the most brakes complaints of any year, with 169.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
3 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jun 201079,000 milesCA
Tl* the contact owns a 1991 Plymouth Voyager. The contact stated while driving AT unknown speeds, the anti-lock braking system warning light illuminated on the dashboard. The dealer advised the ABS system was defective and would need to be replaced, the repair was performed on the vehicle, however, the failure recurred. The manufacturer advised they would contact the dealer but would not provide any assistance. The failure mileage was 79,000 and the current mileage was 80,000.
Owner complaint 10334598 filed with NHTSA
BrakesFiled Jul 2008179,000 milesNJ
Brake failure 1991 Plymouth van ABS system failure pumps brake fluid out top fill caps while parked & runs battery down to dead also hard pedal AT any time fails to stop ABS system was repaired or replaced about 1999 dash warning go on & off AT any time been dealer shop 4 weeks dispute lifetime warranty for recall.
Owner complaint 10236467 filed with NHTSA
BrakesFiled Jun 200673,000 miles
Dt*: the contact stated the brakes do not work properly. While applying pressure the pedal felt spongy and must be pumped several times before the vehicle will stop. An NHTSA recall, # 96v099000 was performed on the vehicle concerning, the service brakes, hydraulic: antilock however, the recall did not remedy the problem. The dealership would not offer a second repair without charge under the recall.
The ABS hydraulic control unit CAN experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Risk and remedy
Risk
If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
Remedy
Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
The anti-lock brake system high pressure pump may be porous which will result in brake fluid leakage.
Risk and remedy
Risk
Fluid leakage eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure pump and high pressure hose if the last six digits of the bar code label on the pump are between 052300 and 059262.
The anti-lock brake system high pressure hose may leak or detach AT its crimped end fitting resulting in the discharge of hydraulic fluid.
Risk and remedy
Risk
Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure hose with a hose of different design and construction.