Owners of the 1996 Pontiac Sunfire have reported 19 steering problems to NHTSA, 9% of all complaints about this model year.
Where owners named a specific part, the most common were rack and pinion (8), steering wheel/handle bar (5), and hydraulic power assist (2).
The typical report came at around 112,000 miles, and complaints were filed between November 1995 and March 2009.
These steering complaints include 1 crash.
For comparison, the 1997 Sunfire has the most steering complaints of any year, with 42.
Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.
1 recall for this model year involves the steering.
If your problem matches, a dealer repairs it free under the recall.
Complaints19
Typical mileage112k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Rack And Pinion8
Steering Wheel/Handle Bar5
Hydraulic Power Assist2
Hydraulic Power Assist System2
Gear Box (Other Than Rack And Pinion)1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SteeringFiled Mar 2009165,000 milesCA
February 25, 2009 - noticed when using the tilt steering lever, the steering column did not lock AT certain levels (lower position). Within a week of noticing this problem, I notice the steering column seemed loose and when it was difficult AT times when turning left. In one incident, nearly lost control of the vehicle when another vehicle veered into my lane on the freeway AT speeds of 65 MPH. I had to over compensate the immediate turn to avoid loosing control of the vehicle and crashing. March 13, 2009 - noise heard when turning or steering the vehicle.
Owner complaint 10262706 filed with NHTSA
SteeringFiled Apr 2007112,000 milesIN
Tl*- the contact owns a 1996 Pontiac Sunfire. The vehicle made a knocking noise when the steering was turned all the way to the left. There was recall 02v286000 for the rack and pinion steering, but it did not include this vehicle due to the VIN. The contact felt that it should be extended since this vehicle had the same failure as stated in the recall.
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.