Owners of the 1998 Pontiac Sunfire have reported 14 steering problems to NHTSA, 12% of all complaints about this model year.
Where owners named a specific part, the most common were rack and pinion (6), column (2), and linkages (1).
The typical report came at around 66,000 miles, and complaints were filed between October 1998 and May 2018.
These steering complaints include 1 crash.
For comparison, the 1997 Sunfire has the most steering complaints of any year, with 42.
Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.
1 recall for this model year involves the steering.
If your problem matches, a dealer repairs it free under the recall.
Complaints14
Typical mileage66k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Rack And Pinion6
Column2
Linkages1
Hydraulic Power Assist System1
Hydraulic Power Assist1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SteeringFiled May 2018165,000 milesFL
While driving the vehicle will shut down and the theft system light with start flashing will start again and but shut down again I was driving on a city street and had it AT a dealer they replaced the ECU the gauges and the ignition they replaced the ECU 3 times with no avail this has happened to all 4 of my pontiacs
Owner complaint 11098157 filed with NHTSA
SteeringFiled Oct 201166,241 milesOK
Apparently, their is a known issue w/the 98 Pontiac Sunfire steering rack and pinion gear making it feel like their is a total loss of power steering, even though the power steering pump is working properly. I purchased this car in January of 2011 off a little old lady, who kept it in a garage and barely drove it, the car only had 51,000 miles on it. She advised that she didn't know of any recalls, so she didn't take it in for any of the recall repairs. I have check the NHTSA website as well as several other reputable sites and have found their have been several recalls on this vehicle.
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began january 24, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, pontiac AT 1-800-762-2737, or oldsmobile AT 1-800-442-6537.