Owners of the 1996 Volvo Wia have reported 5 suspension problems to NHTSA, 63% of all complaints about this model year.
Complaints were filed between November 1999 and May 2002.
For comparison, the 1995 Wia has the most suspension complaints of any year, with 6.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
3 recalls for this model year involve the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileagen/a
Crashes / fires0 / 0
Injuries0
What owners say
SuspensionFiled May 2002NV
Consumer states the truck will not stay aligned, various parts have been replaced to keep the truck aligned such as the tie rod ends, the tires were replaced, shocks, rear torsion bar, right rear air bag, torqued rod arm, replaced rear spring pins, lead springs, u-bolts, air suspension level valve, and the rear axle was reset.
Owner complaint 565603 filed with NHTSA
SuspensionFiled Aug 2001
Transmission problems. *tt also, fifth wheel assembly needed adjustment/ hood was cracked/ there was a missing bolt in crossmember/ there was a leak under the dash/thermostat was replaced/air whistle noise in engine/pulley assembly needed replacement/cool filter replaced/ brake belt replaced/ left front brake was sticking/new brake shoes were needed/ alternator and starter solenoid replaced/ speed control inoperable due to faulty wire,/harness to crank sensor rubbed, causing inactive engine code and wiring harness was shorting out.
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Risk and remedy
Risk
This condition would result in increased stopping distances.
Remedy
Dealers will install the necessary air pressure protection valve.
Vehicle description: heavy duty trucks equipped with design level 1, rockwell ff980 series front axle. The front axle hub flange CAN develop cracks due to high stress levels.
Risk and remedy
Risk
Cracks in a hub flange CAN result in a wheel separation.
Remedy
Dealers will remove and replace the front hubs with an improved design level 2 hub.
Vehicle description: class 8 heavy duty vehicles equipped with eaton drive axles and axilok spindle nuts. The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. The length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.
Risk and remedy
Risk
This locking tab prevents the wheel bearing nut from loosening during vehicle operation. If this tab is deformed, the nut CAN loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.
Remedy
Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.