Owners of the 1997 Volvo Wia have reported 5 suspension problems to NHTSA, 63% of all complaints about this model year.
Where owners named a specific part, the most common were front (1).
Complaints were filed between August 1999 and February 2003.
For comparison, the 1995 Wia has the most suspension complaints of any year, with 6.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
2 recalls for this model year involve the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileagen/a
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Front1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled May 2002
Consumer stated while driving, the truck started to pull very hard to the left and consumer had a very difficult time stopping the truck, once the truck was under control, consumer got out and noticed that the right steer tire was worn down to the very outside edge to the thread, on a separate occasion the front end of the truck was vibrating so bad that the consumer had to pull over, consumer stated that in febuary 1998 the rear suspension was rebuilt.
Owner complaint 565912 filed with NHTSA
SuspensionFiled Apr 2002TN
There is constant shaking in front end of vehicle and in steering wheel, AT any speed. Dealer has replaced tires and aligned vehicle. Did not remedy the problem. Nlm consumer adds that the vehicle is still shaking violently.
Vehicle description: class 8 heavy duty trucks. The air suspension control valve supply line was not plumbed through an air pressure protection valve. In the event of a failure, there would be loss of air pressure in the 'b' system air reservoir that supplies air pressure for the front steer axle brakes.
Risk and remedy
Risk
This condition would result in increased stopping distances.
Remedy
Dealers will install the necessary air pressure protection valve.
Vehicle description: class 8 heavy duty trucks. The steer axle wheel bearing jam nut lock washer may not have been bent over the jam nut after the wheel bearings were adjusted.
Risk and remedy
Risk
If this condition exists, the jam nut and wheel bearing adjusting nut CAN back off the spindle allowing the wheel and the brake drum assembly to separate from the vehicle increasing the risk of a vehicle crash.
Remedy
Dealers will inspect the steering axle wheel bearing jam nut lock washer to determine if it is bent over the jam nut, and if not, repair as required.