Owners of the 1996 Chevrolet S-10 have reported 222 brakes problems to NHTSA, 33% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (171), foundation components (53), and antilock (8).
The typical report came at around 67,000 miles, and complaints were filed between February 1996 and March 2018.
These brakes complaints include 41 crashes and 13 injuries.
For comparison, the 1994 S-10 has the most brakes complaints of any year, with 533.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Mar 2018340,000 milesCACrash
I was involved in a traffic collision in which my brakes failed to stop my vehicle. When I pressed the brakes during a sudden stop, the brakes started to slow down my truck but then the pedal went all the way down to the floor with a rubbing noise and my truck kept traveling until I hit the vehicle in front of me.
Owner complaint 11078842 filed with NHTSA
BrakesFiled Oct 201764,160 milesWA
Tl* the contact owns a 1996 Chevrolet s10. While driving 35 MPH, the ABS malfunctioned. The contact stated that the ABS engaged independently, and pulled the vehicle to the left. Furthermore, the vehicle lost brake functionality completely. Gilcrest Chevrolet buick GMC in tacoma, washington was made aware of the failure and stated that the vehicle needed to be towed to the dealer for diagnostic testing. The contact stated that the brakes had been serviced by the dealer prior to this failure, but the failure recurred. The manufacturer was made aware of the issue and stated that there was no recall on the vehicle.
Owner complaint 11031519 filed with NHTSA
BrakesFiled Jun 2008OHCrash
1996 chevy s10 attempted to slow but had equipment failure with the braking system. Consumer then swerved to the right to avoid hitting the car ahead, drove onto the cement curb, and struck a pole. *nj updated 05/12/10 *bf the brake lines on the left front side and rear were leaking. The fluid reservoir was very low and in fact was empty on the half designated for the rear brake. The driver admitted using the wrong type of brake line fitting when he did the brake servicing. Ohio traffic crash report #10-0433-91 the consumer stated the accident was a result of excessive corrosion on and around the rear axle. Updated 05/14/10.
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Vehicle description: light duty passenger pickup trucks equipped with 4.3l engines. The front brake line CAN contact the left-hand side of the engine oil pan causing the brake line to wear to the point of brake fluid loss during brake application.
Risk and remedy
Risk
Brake fluid loss CAN reduce braking effectiveness and increase stopping distances resulting in a vehicle crash without prior warning.
Remedy
Dealers will inspect the clearance between the oil pan and the brake line. If the clearance is 6mm or less, dealers will install an additional brake line clip and if there was contact between the oil pan and brake line, the front brake line will be replaced.