There are 7 safety recalls on file for the 1996 Chevrolet S-10,
filed between February 1996 and April 2003.
Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1996 S-10 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2003 (1)
03V159000
Filed Apr 28, 2003 1,755,876 vehicles
On certain minivans, pickup trucks, and sport utility vehicles with certain model-engine combinations, the windshield wiper motor may fail due to cracked solder joints on the controller circuit board. The windshield wipers could work intermittently or not AT all.
Risk and remedy
- Risk
- If this were to occur during bad weather, driver visibility would be reduced, which could result in a crash.
- Remedy
- Dealers will replace the wiper motor circuit board and cover. Owner notification began on june 19, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet AT 1-800-222-1020, GMC AT 1-800-462-8782, or oldsmobile AT 1-800-442-6537.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 03023)
1999 (1)
99V193000
Filed Jul 19, 1999 1,125,749 vehicles
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
- Risk
- If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
- Remedy
- Dealers will replace or repair the 4-wheel/2-wheel drive switch.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 99041)
1998 (1)
98V150001
Filed Jul 1, 1998 1,557,585 vehicles
Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector CAN crack causing the windshield wipers to work intermittently.
Risk and remedy
- Risk
- This condition CAN result in inoperative wipers, reducing a driver's visibility, and increasing the risk of a vehicle crash.
- Remedy
- Dealers will replace the wiper motor circuit board and cover.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 98043)
1997 (3)
97V146001
Filed Sep 11, 1997 146,167 vehicles
Vehicle description: light duty passenger pickup trucks equipped with 4.3l engines. The front brake line CAN contact the left-hand side of the engine oil pan causing the brake line to wear to the point of brake fluid loss during brake application.
Risk and remedy
- Risk
- Brake fluid loss CAN reduce braking effectiveness and increase stopping distances resulting in a vehicle crash without prior warning.
- Remedy
- Dealers will inspect the clearance between the oil pan and the brake line. If the clearance is 6mm or less, dealers will install an additional brake line clip and if there was contact between the oil pan and brake line, the front brake line will be replaced.
- Filed by
- GENERAL MOTORS CORP.
97V096001
Filed Jun 12, 1997 586,058 vehicles
Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat CAN separate during a frontal impact.
Risk and remedy
- Risk
- If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
- Remedy
- Dealers will install a protective cover over the recliner mechanism.
- Filed by
- GENERAL MOTORS CORP.
The top coat paint severely peels due to overbaking of the powder primer prior to the top coat application. Since the windshield primer and adhesive adhere to the top coat paint onthe windshield opening flange, the windshield does not comply with federal motor vehicle safety standard no. 212, "windshield mounting."
Risk and remedy
- Risk
- In the event of a vehicle crash, the windshield may not stay in place as required by fmvss no. 212.
- Remedy
- All vehicles have been repurchased. This campaign is 100%.
- Filed by
- GENERAL MOTORS CORP.
1996 (1)
Some of these trucks were built with transmissions containing parts which were not machined to GM's specifications.
Risk and remedy
- Risk
- These transmissions could seize and lock the rear drive wheels while the truck is being driven causing a loss of vehicle control increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect the transmission main shaft output torque using a special tool. If the output torque does not meet specifications, the transmission will be replaced.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1996 Chevrolet S-10 have?
NHTSA lists 7 recalls for the 1996 Chevrolet S-10.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.