There are 3 safety recalls on file for the 1995 Chrysler Sebring,
filed between November 1997 and December 2000.
Each one is repaired free by a franchised Chrysler dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1995 Sebring is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2000 (1)
00V421002
Filed Dec 18, 2000 393,796 vehicles
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.
Risk and remedy
- Risk
- This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
- Remedy
- Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.
- Filed by
- DAIMLERCHRYSLER CORPORATION (manufacturer number 967)
1999 (1)
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude.
Risk and remedy
- Risk
- This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash.
- Remedy
- Dealers will inspect the rubber boots, and if the boot is damaged, they will replace the lower lateral arm and ball joint on the affected vehicles.
- Filed by
- DAIMLERCHRYSLER CORPORATION (manufacturer number 827)
1997 (1)
97V201000
Filed Nov 13, 1997 599,000 vehicles
Vehicle description: passenger vehicles. The lower control arm ball joint CAN separate due to loss of lubrication.
Risk and remedy
- Risk
- Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash.
- Remedy
- Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
- Filed by
- CHRYSLER CORPORATION
Recall questions
How many recalls does the 1995 Chrysler Sebring have?
NHTSA lists 3 recalls for the 1995 Chrysler Sebring.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.