There are 4 safety recalls on file for the 1998 Chrysler Sebring,
filed between March 1998 and January 2004.
Each one is repaired free by a franchised Chrysler dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1998 Sebring is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2004 (1)
04V021000
Filed Jan 13, 2004 2,315,768 vehicles
On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.
Risk and remedy
- Risk
- Either circumstance may result in the vehicle rolling away without warning.
- Remedy
- Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler AT 1-800-853-1403.
- Filed by
- DAIMLERCHRYSLER CORPORATION (manufacturer number C45)
2000 (1)
00V421002
Filed Dec 18, 2000 393,796 vehicles
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.
Risk and remedy
- Risk
- This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
- Remedy
- Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.
- Filed by
- DAIMLERCHRYSLER CORPORATION (manufacturer number 967)
1998 (2)
Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key CAN cause a trapped key condition which CAN result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, CAN break the connecting pin in the shifter.
Risk and remedy
- Risk
- If this happens, the "ignition-park" interlock system will be nonfunctional.
- Remedy
- Dealers will inspect for proper operation of the system. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a "self-adjusting" design.
- Filed by
- CHRYSLER CORPORATION
Vehicle description: passenger vehicles. The dash panel pad CAN shift interferring with the throttle cable control.
Risk and remedy
- Risk
- The throttle cable control would not return to idle increasing the risk of a vehicle crash.
- Remedy
- Dealers will remove a portion of the dash panel pad so it cannot interfere with the throttle cable control.
- Filed by
- CHRYSLER CORPORATION
Recall questions
How many recalls does the 1998 Chrysler Sebring have?
NHTSA lists 4 recalls for the 1998 Chrysler Sebring.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.