Chrysler · Sebring

1998 Chrysler Sebring

Compact car · FWD · Regular

Owners have filed 319 complaints about the 1998 Chrysler Sebring with NHTSA, the 5th highest of 19 Sebring years.

Most reports involve the body and structure: 72 complaints, or 23% of everything filed, followed by brakes (40) and suspension (35). Half of those body reports describe a failure before 83,000 miles.

Complaints for this year mention 36 crashes, 6 fires, 27 injuries, and 1 death. These are owner reports and have not been verified by NHTSA.

NHTSA lists 4 recalls for this model year. The most recent, campaign 04V021000, was filed in January 2004 and concerns the floor shift.

EPA figures put it at up to 23 MPG combined (19 city, 29 highway) in its most efficient version, out of 6 configurations tested, close to the average compact car of its year.

What owners report

Full breakdown
04V021000 Filed Jan 13, 2004 2,315,768 vehicles

Floor shift

On certain passenger vehicles, the floor shifter ignition-park interlock may fail and allow the shifter to be moved out of the park position with the key removed. An inoperative interlock may also allow the key to be removed when the shifter has not been placed in the park position.

Risk and remedy
Risk
Either circumstance may result in the vehicle rolling away without warning.
Remedy
Dealers will install a new load-limiting push rod into the floor shifter lever of the affected vehicles. Owner notification began on june 14, 2004. Owners should contact daimlerchrysler AT 1-800-853-1403.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number C45)
00V421002 Filed Dec 18, 2000 393,796 vehicles

Lower ball joint

Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.

Risk and remedy
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 967)
98V183000 Filed Aug 6, 1998 685,000 vehicles

Park/neutral start interlock switch

Vehicle description: passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key CAN cause a trapped key condition which CAN result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, CAN break the connecting pin in the shifter.

Risk and remedy
Risk
If this happens, the "ignition-park" interlock system will be nonfunctional.
Remedy
Dealers will inspect for proper operation of the system. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a "self-adjusting" design.
Filed by
CHRYSLER CORPORATION

Recent owner reports

Complaints as owners filed them with NHTSA, lightly tidied for readability. They are not verified.

Speed control Filed Dec 2020 154,352 miles TX

On highway 69 I proceeded to passing a semi near craft road. After passing the semi I release my foot off of the throttle, but the car continued to accelerate. Finally AT 102 MPH bouncing my foot on and off the pedal with no change. When going into the corner I then bumped the transmission into neutral and turned the key off. I popped the hood, got out and could see no issue with the cable, still in it's factory location. No binds or kinks I then pushed down on the throttle linkage on the throttle body and it popped loose. I got back in and haven't had another problem since.

Owner complaint 11377278 filed with NHTSA
Transmission and drivetrain Filed Feb 2017 MA

1998 Chrysler Sebring. Consumer writes in regards to transaxle floor shifter ignition/park interlock recall repair history. *smd the consumer wanted to know, if the vehicle was fixed properly, due to the fact the vehicle was recently purchased and the recall was issued in 2005.

Owner complaint 10948248 filed with NHTSA
Fuel system Filed Oct 2015 128,000 miles CA

Tl* the contact owns a 1998 Chrysler Sebring. While driving AT various speeds, the vehicle stalled without warning. The vehicle could be restarted; however, after several attempts the battery was drained. The vehicle was taken to an independent mechanic. The technician diagnosed that the fuel pump needed to be replaced. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was 128,000.

Owner complaint 10780992 filed with NHTSA
23
19city
29highway
23combined MPG
$2,900fuel a year

Most efficient of 6 EPA-tested configurations. Average for 1998 compact cars: 23.7 MPG.

How 1998 compares with other Sebring years

Owner complaints per model year. The highlighted column is this year.

Questions about the 1998 Chrysler Sebring

Does the 1998 Chrysler Sebring have any recalls?

Yes. NHTSA lists 4 recalls for the 1998 Chrysler Sebring, most recently 04V021000 (January 2004) for the floor shift.

What are the most common problems with the 1998 Chrysler Sebring?

Owner complaints to NHTSA most often involve the body and structure (72), brakes (40), and suspension (35).

What gas mileage does the 1998 Chrysler Sebring get?

The EPA rates it at 19 MPG city, 29 MPG highway and 23 MPG combined for its most efficient version.