Owners of the 1999 Chrysler Sebring have reported 33 suspension problems to NHTSA, 13% of all complaints about this model year.
Where owners named a specific part, the most common were front (21) and rear (2).
The typical report came at around 107,000 miles, and complaints were filed between January 2000 and February 2019.
These suspension complaints include 2 crashes and 2 injuries.
For comparison, the 1996 Sebring has the most suspension complaints of any year, with 85.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints33
Typical mileage107k
Crashes / fires2 / 0
Injuries2
Parts named in these complaints
Front21
Rear2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Feb 2019108,000 milesNC
Driving down road, around 10 miles a hour, the car suddenly went clunk on the left side, and would not move. Got out to check, and the entire piece that holds the tire on was laying on the interior of the tire rim.
Owner complaint 11179780 filed with NHTSA
SuspensionFiled Mar 2015129,000 milesMD
Tl* the contact owns a 1999 Chrysler Sebring convertible. While driving approximately 15 MPH, the front end of the vehicle collapsed to the ground. The vehicle was towed to an independent mechanic. The technician diagnosed that the front driver's side lower ball joint and axle fractured. The vehicle was not repaired. There was a recall under NHTSA campaign number: 09e056000 (suspension) however, the recall expired. The manufacturer was not notified of the issue. The approximate failure mileage was 129,000. The VIN was unavailable. Updated 10/3/2017
Owner complaint 10702694 filed with NHTSA
SuspensionFiled Apr 2014168,000 milesPA
Tl* the contact owns a 1999 Chrysler Sebring. The contact stated that while driving approximately 3 MPH, the vehicle became impossible to steer. The vehicle was taken to an independent mechanic who diagnosed that the ball joint was faulty. The manufacturer was notified of the failure. The failure mileage was 168,000.
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.
Risk and remedy
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 967)