Owners of the 2010 Dodge Ram 2500 have reported 152 steering problems to NHTSA, 64% of all complaints about this model year.
Where owners named a specific part, the most common were linkages (7).
The typical report came at around 38,000 miles, and complaints were filed between December 2010 and December 2021.
These steering complaints include 5 crashes and 1 injury.
For comparison, the 2006 Ram 2500 has the most steering complaints of any year, with 231.
Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.
2 recalls for this model year involve the steering.
If your problem matches, a dealer repairs it free under the recall.
Complaints152
Typical mileage38k
Crashes / fires5 / 0
Injuries1
Parts named in these complaints
Linkages7
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SteeringFiled Dec 2021PA
This is the 3rd time this happened to me. The first time I was driving around 55 and the truck started to shake so bad I could not actually hold onto the steering wheel, and I made it to the side of the road. I thought was a flat tire and I pulled over to find nothing wrong. The second was bad as it shook so violently, I was unable to make it to the side of the road, so I hit the brakes in the middle of traffic to stop. This 3rd time I happen to be traveling 65 mph on the interstate in PA and hit a small bump and all of the sudden the truck felt like it was bouncing off of the road.
Owner complaint 11443944 filed with NHTSA
SteeringFiled Sep 2020190,000 milesMI
Tl* the contact owns a 2010 Ram 2500. The contact stated that power steering pump cap did not vent properly and as the contact attempted to check the steering fluid, not realizing that the power steering fluid was under pressure, the fluid exploded and burned the contact's right hand and neck. The burns were second degree. The contact stated that if he did not have sunglasses on, he would have sustained more severe injuries. The contact called the la fontaine chrysler dealer, located in saline, michigan AT: 248-887-4747 and was told that the VIN was not part of NHTSA campaign number: 10v616000 (steering).
Owner complaint 11354897 filed with NHTSA
SteeringFiled May 202060,000 milesAZ
Tl* the contact owns a 2010 Ram 2500. The contact stated that while driving AT 50 MPH, the vehicle rode over a bump in the roadway and experienced the death wobble. The vehicle was taken to several independent mechanics due to the failure to be diagnosed and repaired. The contact stated that the steering track bar, the steering column stabilizer, inner and outer tie rods, steering dampener, ball joints and wheel bearings were replaced however, the failure recurred. A dealer was not notified of the failure. The manufacturer was not contacted and informed of the failure. The failure mileage was 60,000. The VIN was not available.
Chrysler Group LLC (Chrysler) is recalling certain model year 2008-2012 RAM 2500 4X4 and 3500 4X4 trucks, 2008-2012 Dodge RAM 3500 4x2 Cab Chassis, and model year 2008 Dodge RAM 1500 Mega Cab 4x4. The left tie rod assembly may break.
Risk and remedy
Risk
A failure of the tie rod assembly may result in a loss of steering control, increasing the risk of a crash.
Remedy
Chrysler notified owners on January 16, 2014 that dealers would inspect vehicles and replace the steering linkage assembly, if necessary. On or about February 27, 2014, Chrysler ceased its recall remedy program due to parts quality concerns, and then re-initiated it on or about April 14, 2014. In July 2015, and under a consent order with NHTSA, the company agreed to offer owners three options for remedying their vehicles: perform the original remedy, offer to repurchase the vehicle at the fair market value plus 10%, or offer an additional incentive offer towards the purchase of a new Dodge, Jeep, Chrysler, or Fiat vehicle. Chrysler will notify owners of the new recall options in a letter expected to be mailed on August 31, 2015. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N49.
Chrysler is recalling certain model year 2008-2011 dodge ram 2500/3500 4X4, manufactured from february 14, 2008, through march 28, 2011; model year 2008-2011 dodge ram 3500 cab chassis 4x2, manufactured from february 14, 2008, through march 28, 2011; and model year 2008 dodge ram 1500 mega cab 4X4, manufactured from february 14, 2008, through august 15, 2008, because the left tie rod ball stud may fracture. This condition tends to occur during low speed parking lot type maneuvers when the customer is making a tight turn. Additionally, model year 2003-2008 dodge ram 2500/3500 vehicles may have received the affected tie rod assembly as a replacement part during normal service.
Risk and remedy
Risk
This condition could result in the potential loss of directional stability in the left hand front wheel, increasing the risk of a crash.
Remedy
Dealers will inspect the tie rod ends for relative orientation and replace the left outer tie rod as required and perform a front end toe alignment as needed. This service will be performed free of charge. The safety recall began on october 3, 2011. Owners may contact chrysler AT 1-800-853-1403.