Ford · B700

1993 Ford B700 Recalls

Model year 1993

Recalls 5 NHTSA campaigns
Complaints 0 Owner reports to NHTSA
Fuel economy n/a No EPA rating
Crash rating pre-2011 NHTSA 5-Star program

There are 5 safety recalls on file for the 1993 Ford B700, filed between November 1992 and August 1995. Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1993 B700 is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1995 (1)

95V143000 Filed Aug 2, 1995 29,000 vehicles

Vehicle speed control

The hand throttle cable CAN wear the brass swivel block on the governor lever through which it passes.

Risk and remedy
Risk
This wear CAN result in the governor jamming in thedamaged swivel and could prevent the governor lever from returning to the idle position.
Remedy
Dealers will install a revised governor lever with a stainless steel swivel. Also letters will be sent to vehicle owners that have the same vehicles but do not have a ford installed hand throttle advising them that they may require service if they have had an after market hand throttle installed.
Filed by
FORD MOTOR COMPANY

1994 (2)

94V118000 Filed Jun 27, 1994 12,700 vehicles

Rack and pinion

The steering gears have an improperly machined snap ring groove. This CAN cause a fracture of the snap ring with subsequent damage to the recirculating ball guide tube. Also, the o-ring seal in vehicles built after february 1988 does not meet specifications and is inadequate, causing interior leakage around the o-ring / glide ring seal in the steering gear.

Risk and remedy
Risk
The fracture of the snap ring results in increasing deterioration of the ability to turn the vehicle to the right. The driver would experience increased steering efforts or a "crunchy" feeling AT the steering wheel. The inadequate o-ring seal causes momentary reductions in power steering assist AT low speed and certain left turn maneuvers. Both conditions result in decreased steering ability.
Remedy
Dealers will rebuild the steering gear. If a broken snap ring is found during rebuilding, the steering gear will be replaced with a remanufactured unit.
Filed by
FORD MOTOR COMPANY
94V056000 Filed Mar 26, 1994 3,660 vehicles

12v/24v/48v battery

System: electrical system; battery. Vehicle description: medium duty school bus chassis equipped with hydraulic brakes, tilt hoods, 5.9l, 6.6l or 7.6l diesel engines or 6.1l or 7.0l gasoline engines and originally sold or currently registered in connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania ,rhode island, vermont, and wisconsin. The battery power junction block mounted on the right fender apron, which serves as an electrical connection point for several engine compartment systems, is susceptible to road splash. The terminals AT the junction block CAN experience corrosion and CAN fracture, causing loss of electrical power and engine shutdown.

Risk and remedy
Risk
Engine shutdown, loss of power steering assist, or loss of hydraulic brake boost CAN occur which may result in loss of vehicle control and an accident.
Remedy
Dealers will replace the junction box, main power terminal the starter or starter relay and terminals AT the existing junction block. The wiring of the hydraulic brake circuit will also be modified by bypassing the junction block. The new terminals will be made from an alloy material more resistant to salt corrosion.
Filed by
FORD MOTOR COMPANY

1993 (1)

93V160000 Filed Sep 27, 1993 20,000 vehicles

Springs

As a result of inherent vibration in these engines, the throttle return springs CAN fracture.

Risk and remedy
Risk
If one of the two return springs fractures while thevehicle is being driven, a substantial reduction in accelerator pedal effortwould be felt. If the second spring also fractures, the throttle would notreturn to idle position and CAN result in increased engine speed and thepossibility of loss of vehicle control and an accident.
Remedy
The throttle return control system with the coil torsion spring design will be replaced.
Filed by
FORD MOTOR COMPANY

1992 (1)

92V164000 Filed Nov 10, 1992 192 vehicles

Wheels

Risk and remedy
Risk
Using the wrong sized clamps to attach the rim and tireassembly to the wheel spokes could cause the studs that attach the clamps to thespokes to bend. If the studs are bent, there is an increased risk of studfracture that could result in the rim and tire assembly breaking from thewheel.
Remedy
Replace the clamps and studs on the cast spoke wheels.
Filed by
FORD MOTOR COMPANY

Recall questions

How many recalls does the 1993 Ford B700 have?

NHTSA lists 5 recalls for the 1993 Ford B700.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.