There are 3 safety recalls on file for the 1994 Ford B700,
filed between March 1994 and August 1995.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1994 B700 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
A connector in the wiring where the tilt hood mounted lamps attach to the vehicle wiring harness was built without sealing plugs. Moisture, road salt or other contaminants CAN enter the connection resulting in crossed circuits, shorts or corrosion of the wiring of the connector.
Risk and remedy
- Risk
- The headlamps or other front-end lighting systems CAN malfunction as a result of this condition increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect the connector and install sealing plugs in the open cavities. If the inspection reveals corrosion, a new connector will be installed.
- Filed by
- FORD MOTOR COMPANY
System: electrical system; battery. Vehicle description: medium duty school bus chassis equipped with hydraulic brakes, tilt hoods, 5.9l, 6.6l or 7.6l diesel engines or 6.1l or 7.0l gasoline engines and originally sold or currently registered in connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania ,rhode island, vermont, and wisconsin. The battery power junction block mounted on the right fender apron, which serves as an electrical connection point for several engine compartment systems, is susceptible to road splash. The terminals AT the junction block CAN experience corrosion and CAN fracture, causing loss of electrical power and engine shutdown.
Risk and remedy
- Risk
- Engine shutdown, loss of power steering assist, or loss of hydraulic brake boost CAN occur which may result in loss of vehicle control and an accident.
- Remedy
- Dealers will replace the junction box, main power terminal the starter or starter relay and terminals AT the existing junction block. The wiring of the hydraulic brake circuit will also be modified by bypassing the junction block. The new terminals will be made from an alloy material more resistant to salt corrosion.
- Filed by
- FORD MOTOR COMPANY