Owners of the 1996 Ford Contour have reported 119 electrical problems to NHTSA, 21% of all complaints about this model year.
Where owners named a specific part, the most common were wiring (66), alternator/generator/regulator (16), and ignition (15).
The typical report came at around 102,000 miles, and complaints were filed between April 1996 and December 2018.
These electrical complaints include 15 fires.
For comparison, the 1995 Contour has the most electrical complaints of any year, with 180.
Batteries, alternators, wiring, fuses, ignition, instrument clusters, infotainment and body electronics, including warning lights and parasitic drain.
1 recall for this model year involves the electrical.
If your problem matches, a dealer repairs it free under the recall.
Complaints119
Typical mileage102k
Crashes / fires0 / 15
Injuries0
Parts named in these complaints
Wiring66
Alternator/Generator/Regulator16
Ignition15
12V/24V/48V Battery11
Starter Assembly2
Horn1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Electrical systemFiled May 2017TX
The wire harness motor, transmission and fuel injection are bad ,and was stationary 5 year ago like many many many contours and mistyques in my country , I need a solution please, couse responsability is from Ford company in all the world. Thank you. I AM in mexico.
Owner complaint 10991732 filed with NHTSA
Electrical systemFiled May 2016100,000 milesALFire
Tl* the contact owns a 1996 Ford Contour. The contact stated that while attempting to start the vehicle, it would fail to start due to a melted wire in the engine. In addition, the contact stated that the odometer failed to provide the accurate reading. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was 100,000.
Owner complaint 10864256 filed with NHTSA
Electrical systemFiled Oct 201558,606 milesWA
Car was purchased from a used car dealer on 8/11/15. The car has 58606 miles on it. The transmission had to be replaced due to electrical issues caused by a faulty wiring harness. Wiring harness was under the owner notification and not repaired. Ford has not offered any type of assistance and mechanic says the car is a fire hazard and harness has to be replaced. Contacted Ford who said the car was not under any type of recall and they no longer make the part.
On certain my 1996-1998 passenger vehicles built AT the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built AT the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades CAN damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition.
Risk and remedy
Risk
The open circuit could lead to electrical arcing that could melt the connector housing material creasing the potential for a fire.
Remedy
Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.