Owners of the 1998 Ford Contour have reported 130 electrical problems to NHTSA, 15% of all complaints about this model year.
Where owners named a specific part, the most common were wiring (59), ignition (15), and starter assembly (10).
The typical report came at around 85,000 miles, and complaints were filed between November 1998 and November 2018.
These electrical complaints include 2 crashes, 13 fires, and 2 injuries.
For comparison, the 1995 Contour has the most electrical complaints of any year, with 180.
Batteries, alternators, wiring, fuses, ignition, instrument clusters, infotainment and body electronics, including warning lights and parasitic drain.
1 recall for this model year involves the electrical.
If your problem matches, a dealer repairs it free under the recall.
Complaints130
Typical mileage85k
Crashes / fires2 / 13
Injuries2
Parts named in these complaints
Wiring59
Ignition15
Starter Assembly10
Alternator/Generator/Regulator7
Horn3
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Electrical systemFiled Nov 2018147,000 milesPA
Was driving down route 322 on day and had to hit the break and all of a sudden they went to the floor. I pulled over and checked my break fluid resivour and it was empty. I think the passenger side drum break is leaking fluid.
Owner complaint 11153195 filed with NHTSA
Electrical systemFiled Nov 2013163,000 milesMI
I just traded and got this car, it seems to sway in the back going over wet roads or bumpy roads not sure what it is, but I fear my safety as the previous owner did not tell me about this. I also have noticed that the temperature gauge does not work and the heater blower only works on high. I cannot afford to get things fixed if there is recalls on them.
Owner complaint 10553556 filed with NHTSA
Electrical systemFiled Aug 2013LA
I AM the owner of a 1998 Ford Contour and the engine harness wire overheated over a long period of time and I was unaware until I had to change my radiator due to a leak and the harness wire had to be disconnected. That was when we found the wire melted and cracked and could not be reused. This harness connects to vehicle main supply. Without harness vehicle is not operable. Ford should be responsible to replace defective harness.
On certain my 1996-1998 passenger vehicles built AT the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built AT the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades CAN damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition.
Risk and remedy
Risk
The open circuit could lead to electrical arcing that could melt the connector housing material creasing the potential for a fire.
Remedy
Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.