Owners have filed 846 complaints about the 1998 Ford Contour with NHTSA, the 2nd highest of 9 Contour years.
Most reports involve the engine: 135 complaints, or 16% of everything filed, followed by electrical system (130) and transmission and drivetrain (128). Half of those engine reports describe a failure before 72,000 miles.
Complaints for this year mention 50 crashes, 20 fires, 54 injuries, and 4 deaths. These are owner reports and have not been verified by NHTSA.
NHTSA lists 9 recalls for this model year. The most recent, campaign 01V255000, was filed in August 2001 and concerns the coil springs.
EPA figures put it at up to 25 MPG combined (21 city, 32 highway) in its most efficient version, out of 4 configurations tested, close to the average compact car of its year.
Vehicle description: passenger vehicles built AT the kansas city assembly plant and originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin, and the district of columbia. The front coil springs may fracture as a result of corrosion in high corrosion environments. Depending on the location of the fracture, a broken spring could move past the spring seat and contact a front tire.
Risk and remedy
- Risk
- Some tires have deflated due to contact with a broken spring.
- Remedy
- Dealers will install spring catcher brackets. Owner notification began october 23, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 01S23)
On certain my 1996-1998 passenger vehicles built AT the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built AT the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades CAN damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition.
Risk and remedy
- Risk
- The open circuit could lead to electrical arcing that could melt the connector housing material creasing the potential for a fire.
- Remedy
- Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 01S22)
Vehicle description: bi-fuel vehicles. These vehicles may have a fuel tank filler pipe grommet that could have been damaged during the installation of the bi-fuel system. If the grommet is damaged, fuel could leak. Fuel leakage in the presence of an ignition source could result in a fire. Dealers will replace the fuel tank filler pipe grommet.
Risk and remedy
- Risk
- If the grommet is damaged, fuel could leak. Fuel leakage in the presence of an ignition source could result in a fire.
- Remedy
- Dealers will replace the fuel tank filler pipe grommet.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S38)