2008 Ford Crown Victoria Problems
Large car · RWD · Gasoline or E85
Owners have filed 50 complaints about the 2008 Ford Crown Victoria with NHTSA's vehicle safety hotline and website. The steering leads with 25, then the speed control with 11. Reports for this year mention 11 crashes, 3 fires, and 6 injuries.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Steering 50% of complaints · median 97,000 miles · Linkages 25
- Speed control 22% of complaints · median 111,000 miles · Accelerator Pedal 11
- Suspension 12% of complaints · median 62,000 miles · Front 6
- Electrical system 10% of complaints · median 73,000 miles · Wiring 5
- Brakes 6% of complaints · median 61,000 miles 3
- Transmission and drivetrain 6% of complaints · median 105,000 miles 3
- Body and structure 4% of complaints · median 28,000 miles · Body 2
- Other or unknown 4% of complaints · median 130,000 miles 2
- Engine 4% of complaints · median 54,000 miles · Engine 2
- Fuel system 4% of complaints · median 143,000 miles · Storage 2
- Lights 2% of complaints · median 122,000 miles · Headlights 1
- Air bags 2% of complaints 1
- Seat belts 2% of complaints · median 2,000 miles · Front 1
Latest owner reports
Complete instrument cluster failure, no lights illuminate except turn signals. Speed, rpmâs, fuel level, temperature, are completely off instrument cluster is completely dark when driving at night, told that the solders on the cluster are bad. (Defective?)
The contact owns a 2008 Ford Crown Victoria. The contact stated that while driving at an undisclosed speed, the vehicle experienced a loss of power steering assist. The contact inspected the steering column underneath the hood and noticed that the steering shaft was corroded. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The contact related the failure to NHTSA Campaign Number: 13V385000 (Steering) however, the VIN was not included in the recall. The failure mileage was approximately 141,000.
The right front wheel hub broke at the weld when turning in a parking lot. The part is available for inspection. Had this happened at freeway speed, the right front wheel would have departed the vehicle. The safety hazards are obvious. I attempted to contact customer service and they did not reply.There was no warning sign and the part has not been inspected. I am not a welder. It appears this part had a bad weld from the start. I suspect it was welded by a machine and there may be more just like it from the same production run.
Tl* the contact owns a 2008 Ford Crown Victoria. The contact stated that while driving AT 70 MPH, the steering wheel independently turned 180 degrees. The contact regained control of the vehicle, and pulled over and parked the vehicle. The contact inspected the vehicle and became aware of a loosened steering shaft bushing. The vehicle was towed to the residence. Neither the dealer nor the manufacturer were notified of the failure. The approximate failure mileage was 166,000.