Ford · Crown Victoria

2008 Ford Crown Victoria Steering Problems

Large car · RWD · Gasoline or E85

Owners of the 2008 Ford Crown Victoria have reported 25 steering problems to NHTSA, 50% of all complaints about this model year.

Where owners named a specific part, the most common were linkages (1).

The typical report came at around 97,000 miles, and complaints were filed between August 2010 and August 2022.

These steering complaints include 4 crashes, 1 fire, 2 injuries, and 1 death.

For comparison, the 1995 Crown Victoria has the most steering complaints of any year, with 99.

Power steering pumps and electric assist, racks, columns, tie rods and sudden loss of steering assist.

2 recalls for this model year involve the steering. If your problem matches, a dealer repairs it free under the recall.
Complaints25
Typical mileage97k
Crashes / fires4 / 1
Injuries2

Parts named in these complaints

  • Linkages1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Steering Filed Aug 2022 141,000 miles MI

The contact owns a 2008 Ford Crown Victoria. The contact stated that while driving at an undisclosed speed, the vehicle experienced a loss of power steering assist. The contact inspected the steering column underneath the hood and noticed that the steering shaft was corroded. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The contact related the failure to NHTSA Campaign Number: 13V385000 (Steering) however, the VIN was not included in the recall. The failure mileage was approximately 141,000.

Owner complaint 11480958 filed with NHTSA
Steering Filed Jul 2022 CA

The right front wheel hub broke at the weld when turning in a parking lot. The part is available for inspection. Had this happened at freeway speed, the right front wheel would have departed the vehicle. The safety hazards are obvious. I attempted to contact customer service and they did not reply.There was no warning sign and the part has not been inspected. I am not a welder. It appears this part had a bad weld from the start. I suspect it was welded by a machine and there may be more just like it from the same production run.

Owner complaint 11476597 filed with NHTSA
Steering Filed Jun 2020 166,000 miles WI

Tl* the contact owns a 2008 Ford Crown Victoria. The contact stated that while driving AT 70 MPH, the steering wheel independently turned 180 degrees. The contact regained control of the vehicle, and pulled over and parked the vehicle. The contact inspected the vehicle and became aware of a loosened steering shaft bushing. The vehicle was towed to the residence. Neither the dealer nor the manufacturer were notified of the failure. The approximate failure mileage was 166,000.

Owner complaint 11330032 filed with NHTSA

Related recalls

14V704000 Filed Nov 5, 2014 36,888 vehicles

Pinion shaft

Ford Motor Company (Ford) is recalling certain model year 2005-2011 Ford Crown Victoria, 2005-2011 Mercury Grand Marquis vehicles manufactured March 23, 2004, to August 30, 2011, and 2005-2011 Lincoln Town Car vehicles manufactured March 8, 2004, to August 30, 2011, and on which the upper intermediate shaft was serviced during the course of safety recall 13V-385. The prior repairs may not have been correctly performed.

Risk and remedy
Risk
Improper servicing of the upper intermediate shaft could cause the shaft to separate, which can then result in a loss of steering control, and increasing the risk of a crash.
Remedy
Ford will notify the owners of vehicles whose repair records reflect that the upper intermediate steering shaft was repaired during the course of the prior recall 13V-385. Dealers will inspect and replace the upper immediate shaft if necessary free of charge. The recall began November 17, 2014. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 14S25.
Filed by
Ford Motor Company (manufacturer number 14S25)
13V385000 Filed Aug 29, 2013 355,000 vehicles

Steering

Ford is recalling certain model year 2005-2011 Ford Crown Victoria (including Crown Victoria Police Interceptors), Mercury Grand Marquis, and Lincoln Town Car vehicles. The affected vehicles are currently registered or were originally sold in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. Severe corrosion can seize the lower intermediate shaft which may cause the upper intermediate shaft to collapse and the steering column lower bearing to separate.

Risk and remedy
Risk
If the lower bearing separates, the vehicle may experience a loss of steering, increasing the risk of a crash.
Remedy
Ford will notify owners and dealers will replace the lower intermediate shaft, free of charge. The upper intermediate shaft and steering column lower bearing will be inspected to identify any damage that may have occurred as a result of lower intermediate shaft corrosion, and repaired or replaced as necessary. If the steering column lower bearing has separated, a retainer clip will be installed. The recall began on October 23, 2013. Owners may contact Ford at 1-866-436-7332. Ford's recall number is 13S08.
Filed by
Ford Motor Company (manufacturer number 13S08)

Steering complaints across Crown Victoria years

Questions about steering problems

How common are steering problems on the 2008 Ford Crown Victoria?

25 owners have reported steering problems to NHTSA, 50% of all complaints for this model year.

Is there a recall for steering problems on the 2008 Ford Crown Victoria?

Yes. 2 recalls for this model year concern the steering: 14V704000, 13V385000.