Owners of the 1992 Ford Explorer have reported 99 brakes problems to NHTSA, 16% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (84), antilock/traction control/electronic limited slip (43), and power assist (8).
The typical report came at around 157,000 miles, and complaints were filed between January 1995 and January 2012.
These brakes complaints include 14 crashes, 3 fires, and 6 injuries.
For comparison, the 1994 Explorer has the most brakes complaints of any year, with 261.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jan 2012WV
Tl* the contact owns a 1992 Ford Explorer. The contact stated that when depressing the brakes AT low speeds, she noticed a grinding noise. The vehicle was inspected by an independent mechanic and they advised her that the front driver and passenger side brakes and rotors needed to be replaced. In addition, when turning the heater on she could smell anti-freeze and also noticed a leak. The independent mechanic advised her that the heater coil as well as the brake lines needed to be replaced due to severe rusting. The vehicle was not repaired. The manufacturer had not been contacted. The failure and the current mileages were unknown.
Owner complaint 10446007 filed with NHTSA
BrakesFiled May 2010220,000 milesCA
Tl* the contact owns a 1992 Ford Explorer. The contact stated the brake pedal would feel spongy when depressed and would increase stopping distance. The vehicle previously received repairs under NHTSA recall campaign ID number 96v024001 (service brakes, hydraulic: power assist: hydraulic). The vehicle was inspected by an independent mechanic who advised that there was a missing stud and nut from the master cylinder. The manufacturer advised that the vehicle was already repaired under the recall campaign and would not provide any assistance. The vehicle was not repaired. The failure and current mileages were 220,000.
Owner complaint 10331433 filed with NHTSA
BrakesFiled Aug 2001CA
Brake studs that attached master cylinder to power brake vacuum booster assembly broke. Brake pedal went down to floor,and didnot stop vehicle. Had to use emergency brakes to stop vehicle.
The studs which attach the brake master cylinder to the power brake vacuum booster assembly CAN develop stress corrosion cracking after being operated for an extended period of time in the southern california location.
Risk and remedy
Risk
If a crack occurs, it could result in one or both studs fracturing. The master cylinder could then separate from the vacuum booster, when the brakes are applied, preventing the service brakes from activating increasing the risk of a vehicle accident.
Remedy
Dealers will replace the power brake vacuum booster assembly.