Owners of the 1993 Ford Explorer have reported 244 brakes problems to NHTSA, 26% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (149), foundation components (90), and conventional (19).
The typical report came at around 143,000 miles, and complaints were filed between January 1995 and July 2020.
These brakes complaints include 20 crashes and 15 injuries.
For comparison, the 1994 Explorer has the most brakes complaints of any year, with 261.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jul 202068,000 milesNY
Tl* the contact owns a 1993 Ford Explorer. The contact stated that while driving approximately 20 MPH, the brake pedal was depressed and went to the floorboard without warning. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that the ABS module failed and needed to be replaced. The contact stated that the replacement part was unavailable. The contact was unable to reach the manufacturer for assistance. The vehicle was not repaired. The failure mileage was approximately 68,000.
Owner complaint 11340967 filed with NHTSA
BrakesFiled Jul 2006143,231 milesNJ
During normal operation left rear brake line cracked, lost all brake fluid, managed to stop vehicle on in median, had vehicle towed to repair shop, after left rear brake line was replaced mechanic was bleeding brake system, during the process the main brake line leading to the rear brake lines cracked and developed a leak, lost all brake fluid again!fortunately this time it happened AT shop, had all brake lines replaced, advised shop to hold on to old (original) brake lines.
Owner complaint 10163894 filed with NHTSA
BrakesFiled Oct 2005163,000 milesNC
Dt: the contact had a problem with the parking brake staying in place. The parking brake goes to the floor and does not hold. This has been happening for a year. The vehicle has not been checked by a dealer. *ak updated 01/23/06.
The studs which attach the brake master cylinder to the power brake vacuum booster assembly CAN develop stress corrosion cracking after being operated for an extended period of time in the southern california location.
Risk and remedy
Risk
If a crack occurs, it could result in one or both studs fracturing. The master cylinder could then separate from the vacuum booster, when the brakes are applied, preventing the service brakes from activating increasing the risk of a vehicle accident.
Remedy
Dealers will replace the power brake vacuum booster assembly.
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Risk and remedy
Risk
When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Remedy
A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.