There are 6 safety recalls on file for the 1993 Ford F-250,
filed between August 1993 and February 2008.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1993 F-250 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2008 (1)
Ford is recalling 225,000 my 1992-2003 econoline, my 1993-1995 taurus sho, my 1992-1998 crown victoria, my 1993 bronco, f-series, my 1995-1997 f-series super duty stripped chassis, my 1992-1998 mercury grand marquis, and my 1992-1995 lincoln town car vehicles. The affected vehicles were previously repaired using a wiring harness that is not compatible with the vehicle circuit polarity.
Risk and remedy
- Risk
- As a result, the fuse is located in the output circuit rather than in the intended input power feed circuit, and may not offer the intended protection in the event of an electrical short to ground.
- Remedy
- Dealers will install a new wiring harness, or replace the mating electrical component. The recall began on february 18, 2008. Owners may contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 08S01)
2007 (1)
07V336000
Filed Aug 3, 2007 3,600,000 vehicles
On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.
Risk and remedy
- Risk
- This could result in an underhood fire.
- Remedy
- Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact ford AT 1-888-222-2751.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 05S28)
2000 (1)
00V424000
Filed Dec 29, 2000 275,000 vehicles
Vehicle description: light duty trucks and cab chassis equipped with gasoline engines and dual fuel tanks. The carbon steel fuel pressure regulator in the fuel system CAN wear out during the life of the vehicle. If the fuel pressure regulator malfunctions, it CAN cause high fuel system pressure, which damages the fuel pump check valve. This allows fuel to be transferred from one tank to the other, possibly overfilling the non-operating tank, resulting in fuel overflow past the filler cap.
Risk and remedy
- Risk
- Fuel leakage in the presence of an ignition source could result in a vehicle fire.
- Remedy
- Dealers will have a stainless steel fuel pressure regulator installed. Owner notification began july 9, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332. (see previous NHTSA recall 93v-125/ford recall 93s68).
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S57)
1994 (2)
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Risk and remedy
- Risk
- When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
- Remedy
- A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
- Filed by
- FORD MOTOR COMPANY
The u-clip style nuts that retain the front bumpers to the front bumper inner arms CAN fracture.
Risk and remedy
- Risk
- If one of the u-clip nuts fractures, the bumper will loosen and rattle causing fracture of the remaining u-clip nuts, resulting in separation of the bumper from the vehicle. If the bumper were to detach from the vehicle while it is being driven, a vehicle collision could result.
- Remedy
- Inspection and replacement of the four u-clip nuts and the associated bolts.
- Filed by
- FORD MOTOR COMPANY
1993 (1)
93V125000
Filed Aug 2, 1993 1,131,000 vehicles
A malfunctioning check valve within the fuel pump assembly causes a portion of the unused fuel from one tank to be returned to the second tank. When this occurs, the capacity of the second tank CAN be exceeded, causing fuel spillage.
Risk and remedy
- Risk
- Spilled fuel CAN result in a fire when exposed to asource of ignition.
- Remedy
- Replacement of the fuel pressure regulator and installation of redundant check valves.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1993 Ford F-250 have?
NHTSA lists 6 recalls for the 1993 Ford F-250.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.