Owners of the 1994 Ford F-350 have reported 33 brakes problems to NHTSA, 35% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (26), antilock/traction control/electronic limited slip (16), and pedals and linkages (1).
The typical report came at around 212,000 miles, and complaints were filed between February 1995 and March 2005.
These brakes complaints include 1 crash and 1 injury.
For comparison, the 1999 F-350 has the most brakes complaints of any year, with 78.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Mar 2005299,000 milesMO
Brake fade. When AT a complete stop, pedal will sink slowly but not enough to active a warning light. If pedal is not pressed harder vehicle will roll. Dealership says this is not the first vehicle to do this and has contacted the manufacturer. Vehicle still does it to this day. Master cylinder has been replaced twice, still not fixed.
Owner complaint 10116063 filed with NHTSA
BrakesFiled Mar 2004125,000 milesIA
While pulling a trailer loaded with fire wood, the brakes failed AT an intersection. The brake pedal went nearly to the floor. The brakes would not slow me down. The emergency brake was not stong enough to stop me while loaded. Had to down shift to stop. The brake line going to the rear axle had a hole in it. The hole was located AT one on clamps to the frame.
Owner complaint 10061915 filed with NHTSA
BrakesFiled Apr 2001GA
Brakes would randomly not operate properly. Would fail to stop vehicle when applied. Brake pedal would drop,but not to floor. Would go through stop lights and intersections. Took vehicle to dealer , it was test driven. Mechanic replaced master cylinder. But, problem still exists.
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Risk and remedy
Risk
When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Remedy
A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.