Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 2025NYCrash
No warning while exiting, I was able to hit the brakes. Then, when I reached for the brakes again, it didnât break. There was no signals on the car. The car is total damage air bags came out.
Owner complaint 11680768 filed with NHTSA
BrakesFiled Aug 2020128,000 milesMO
Tl* the contact owns a 2002 GMC Yukon. The contact stated after he drove the vehicle AT a very low speed, the vehicle unexpectedly experienced unwanted antilock brake system (ABS) activation. The contact stated he was forced to drive AT a higher speed in order to avoid this issue. The contact notified the dealer, cable dahmer buick GMC of kansas city address: 907 w 104th st, kansas city, mo 64114) however the vehicle was not diagnosed or repaired. The manufacturer was made aware and offered little assistance. The failure mileage was 128,000. The contact referenced the failure to NHTSA campaign number: 05v379000 (service brakes, hydraulic).
Owner complaint 11343897 filed with NHTSA
BrakesFiled Oct 2017112,000 milesNC
The first occurance was a year ago when driving to play golf. When I was about one mile from the course, the brake pedal went to the floor when depressed. I was able to make to the course and called a tow truck. The repair was made by the local dealer. He asked me if I lived AT the coast due to the corrosion found on the brake line. I do not live near the coast and the vehicle is garage kept with only 102,000 miles on it. Most recently while driving in town, I depressed the brake pedal and the same thing happened. It went to the floor and was very slow to stop. In my estimation, this is very poor workmanship on behalf of general motors!
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
Risk
This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
Remedy
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.