Owners have filed 8 complaints about the 1992 BMW 318i with NHTSA, the 5th highest of 10 318i years.
The largest share concerns the engine (5 complaints, 63% of the total), followed by air bags (1) and electrical system (1). Half of those engine reports describe a failure before 57,000 miles.
NHTSA lists 3 recalls for this model year. The most recent, campaign 98V178000, was filed in August 1998 and concerns the cooling system.
EPA figures put it at up to 22 MPG combined (19 city, 27 highway) in its most efficient version, out of 2 configurations tested, 3 MPG worse than the average subcompact car of 1992.
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Risk and remedy
- Risk
- If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
- Remedy
- Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
- Filed by
- BAYERISCHE MOTOREN WERKE
97V131000
Filed Aug 19, 1997 410,000 vehicles
The cruise control and throttle cables are attached to the same throttle valve actuating lever AT the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing CAN separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
Risk and remedy
- Risk
- This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
- Remedy
- Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
- Filed by
- BAYERISCHE MOTOREN WERKE
The air bag contact ring locking tab located in the steering wheel assembly CAN break without warning.
Risk and remedy
- Risk
- If this happens, the contact ring wiring could eventually break. The air bag readiness indicator lamp (SRS or airbag) in the instrument cluster will illuminate, and the air bag would not deploy in the event of a frontal impact vehicle collision.
- Remedy
- Dealers will replace the locking tab with one of a different design.
- Filed by
- BAYERISCHE MOTOREN WERKE