Owners have filed 4 complaints about the 1995 BMW 318ic with NHTSA, more than any other 318ic model year on record.
The largest share concerns the lights (1 complaint, 25% of the total), followed by air bags (1) and electrical system (1).
Complaints for this year mention 1 fire and 1 injury. These are owner reports and have not been verified by NHTSA.
NHTSA lists 3 recalls for this model year. The most recent, campaign 98V178000, was filed in August 1998 and concerns the cooling system.
EPA figures put it at up to 22 MPG combined (19 city, 29 highway) in its most efficient version, out of 2 configurations tested, 2 MPG better than the average minicompact car of 1995.
Vehicle description: passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, CAN result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
Risk and remedy
- Risk
- If a crack were to form or a seam were to separate in the heater core end piece, hot coolant could suddenly be expelled, increasing the risk of personal injury to a vehicle occupant.
- Remedy
- Dealers will install a new design radiator cap to control pressure and provide greater coolant overflow in the event of overheating.
- Filed by
- BAYERISCHE MOTOREN WERKE
97V131000
Filed Aug 19, 1997 410,000 vehicles
The cruise control and throttle cables are attached to the same throttle valve actuating lever AT the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing CAN separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
Risk and remedy
- Risk
- This could cause the throttle valve to remain partially open. It his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
- Remedy
- Dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
- Filed by
- BAYERISCHE MOTOREN WERKE
An overstatement was made of the vehicle load capacity and designated seating capacity on the tire information placard. This does not meet the requirements of fmvss no. 110, "tire selection and rims."
Risk and remedy
- Risk
- Consequence of non-compliance: loading of the vehicle beyond the capacity weight CAN cause tire and vehicle damage that CAN result in a vehicle crash.
- Remedy
- Owners will be mailed a revised placard containg the correct vehicle and designated seating capacities and instructions for installing the placard on their vehicles. If owners prefer, their dealer CAN install the placard for them.
- Filed by
- BAYERISCHE MOTOREN WERKE