Owners of the 1997 Ford Crown Victoria have reported 57 brakes problems to NHTSA, 20% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (42), antilock/traction control/electronic limited slip (5), and power assist (4).
The typical report came at around 75,000 miles, and complaints were filed between November 1997 and March 2016.
These brakes complaints include 3 crashes, 1 fire, and 3 injuries.
For comparison, the 1992 Crown Victoria has the most brakes complaints of any year, with 74.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Mar 201675,000 milesNJ
Hydraulic line to rear brake failed (ruptured) causing immediate release of brake fluid underneath driver front floor pan AT location of interest mentioned in recall/"safety improvement program". Owner was not contacted regarding notice which includes inspection of brake lines, replacement of clips (to avoid wear) and possible replacement of brake line and bleeding if needed.
Owner complaint 10851721 filed with NHTSA
BrakesFiled Nov 2010167,000 milesNV
Tl*the contact owns a 1997 Ford Crown Victoria that is equipped with a police interceptor. While driving approximately 2-3 MPH the brakes failed. She applied pressure to the brakes in order to stop the vehicle but it did not stop. When the vehicle did stop in the middle of the street it had to be pushed onto the side of the road. The vehicle was towed to her residence. The vehicle was taken to a local mechanic who advised her of recall 98i001000, service brakes, hydraulic foundation, hoses, lines/piping, and fittings. She called the manufacturer and the dealer who advised her that her vehicle was not part of the recall.
Owner complaint 10366425 filed with NHTSA
BrakesFiled Aug 2008105,000 milesNJ
Steel brake line on 1997 Ford Crown Victoria rusted out. Brake fluid leaked out making the brakes inoperative. Had repairs done AT local mechanic who said this is a frequent occurrence. This is definitely a safety issue.
On certain passenger vehicles built with electronic traction control, the rear brake line may chafe due to contact between it and a floor pan stiffening rib, and a brake fluid leak may occur.
Risk and remedy
Risk
The brake pedal may develop a "spongy" feel and drops of brake fluid may be observed beneath the vehicle. Over time brake performance may be compromised and stopping distances could be extended which could lead to a crash.
Remedy
Dealers will inspect the subject vehicles for contact between the brake tube and floor pan stiffening rib. If contact is evident, but no abrasion or leaks exist, the brake tube will be repositioned to preclude further contact and potential abrasion. If indication of abrasion or a leak is evident, dealers will repair the brake line. This campaign began on july 15, 2005. Owners may contact ford AT 1-800-392-3673.