Owners have filed 44 complaints about the 2024 Ford Edge with NHTSA, the 17th highest of 19 Edge years.
The largest share concerns the electrical system (8 complaints, 18% of the total), followed by driver assistance (8) and transmission and drivetrain (5). Half of those electrical reports describe a failure before 4,000 miles.
Complaints for this year mention 5 crashes and 5 injuries. These are owner reports and have not been verified by NHTSA.
NHTSA lists 2 recalls for this model year. The most recent, campaign 26V124000, was filed in March 2026 and concerns the software.
EPA figures put it at up to 23 MPG combined (21 city, 28 highway) in its most efficient version, out of 3 configurations tested, 5 MPG worse than the average small SUV of 2024.
Ford Motor Company (Ford) is recalling certain 2021-2026 Ford Bronco and 2021-2024 Ford Edge vehicles. The Accessory Protocol Interface Module (APIM) may overheat and shutdown, which can prevent the rearview camera image from displaying as intended.
Risk and remedy
- Risk
- A rearview camera that fails to display an image can reduce the driverâs view behind the vehicle, increasing the risk of a crash.
- Remedy
- The APIM software will be updated by a dealer, or through an over-the-air (OTA) update, free of charge. Owner notification letters were mailed April 13, 2026. Owners may contact Ford Customer Service at 1-866-436-7332. Ford's number for this recall is 26S09. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on March 5, 2026.
- Filed by
- Ford Motor Company (manufacturer number 26S09)
25V315000
Filed May 9, 2025 1,076,138 vehicles
Ford Motor Company (Ford) is recalling certain 2021-2024 Bronco, F-150, 2021-2024 Edge, 2022-2025 Escape, F-250, F-350, F-450, F-550, F-600, 2022-2024 Expedition, 2022-2025 Transit, 2021-2023 Mach-E, 2024 Ranger, Mustang, 2021-2023 Lincoln Nautilus, 2022-2024 Navigator, and 2023-2024 Corsair vehicles. A software error may cause the rearview camera image to delay, freeze, or not display when the vehicle is in reverse.
Risk and remedy
- Risk
- A frozen or missing rearview camera image can reduce the driver's view behind the vehicle, increasing the risk of a crash.
- Remedy
- The accessory protocol interface module (APIM) software will be updated by a dealer or through an over-the-air update, free of charge. This will be a phased campaign, with the remedy becoming available in different phases based on model and model years. Interim letters notifying owners of the safety risk were mailed on June 26, 2025. Additional letters will be mailed once the final remedy is available on each phase. Owner notification letters were sent on October 8, 2025. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25S49.
- Filed by
- Ford Motor Company (manufacturer number 25S49)